Turbocharger - Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 5P-3931 | 防粘结剂 | - |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 在排气歧管的涡轮增压器安装双头螺栓上涂抹工具 (A)。
Show/hide table
图 1 g01270689 - 将适当起吊设备连在涡轮增压器 (1) 上。 涡轮增压器 (1) 的重量约为
27 kg (60 lb) 。 在排气歧管上定位密封垫和涡轮增压器 (1)。注: 弃置使用过的螺母。 安装时使用新螺母。
- 安装螺母 (3)。 拧紧螺母 (3) 至扭矩为
54 ± 5 N·m (40 ± 4 lb ft) 。 - 放置好管组件 (4) 并安装螺栓 (5)。
- 连接软管组件 (2)。
Caterpillar Information System:
C13 On-highway Engine Front Housing and Covers
C9 Engine for Caterpillar Built Machines Turbocharger - Remove
C15 On-Highway Engine Crankshaft
C9 Generator Set Model View Illustrations
C9 Generator Set Plate Locations and Film Locations
C13 On-highway Engine Engine Oil Filter Base
C9 Generator Set Safety Messages
C15 On-Highway Engine Camshaft
349F and 352F Excavators Machine System Specifications Travel Counterbalance Valve
C2.2 Generator Sets Control Panel
C7 and C9 On-highway Engines Fuel System - Prime
TH48-E80 Petroleum Transmission Pressure Control Valve (Transmission)
C9 Engine for Caterpillar Built Machines Cylinder Head - Remove
C15 On-Highway Engine Electronic Unit Injector
2006/02/06 A New Exhaust Manifold Gasket is Used {1059}
C15 and C18 Engines for Caterpillar Built Machines Electronic Unit Injector Rocker Arm
C2.2 Generator Sets Starting the Engine
C15 and C18 Engines for Caterpillar Built Machines Valve Rocker Arm
C15 and C18 Engines for Caterpillar Built Machines Gear Group (Front)
C9 Engine for Caterpillar Built Machines Cylinder Head - Install
C-10 Petroleum Engine Engine Oil Pump - Remove
C280 Marine and Petroleum Engines Engine Speed/Timing Sensor
C3.3 and C4.4 Rental Generator Sets Stopping the Engine
C6.6 Industrial Engine Introduction