Camshaft
Note: Before installation of the camshaft, ensure that the camshaft and the camshaft bearings are clean. lubricate the camshaft lobes with a 50/50 mixture of 8T-2998 Lubricant and clean engine oil. Apply a thin coat of clean engine oil on the camshaft bearings.
Show/hide table
Illustration 1 | g01525229 |
(1) Exhaust lobe (2) Injector lobe (3) Inlet lobe (4) Front of camshaft |
(A) Diameter of camshaft journals ... 84.85 mm (3.341 inch)
Show/hide table
Illustration 2 | g01525234 |
Use the following procedure in order to determine the actual lobe lift :
- Measure the camshaft lobe height (C) .
- Measure the base circle (D) .
- Subtract the base circle (D) from the lobe height (C) . The difference is the actual lobe lift .
(B) Specified camshaft lobe lift
- Exhaust lobe ... 8.515 mm (0.3352 inch)
- Injector lobe ... 10.906 mm (0.4294 inch)
- Inlet lobe ... 9.625 mm (0.3789 inch)
- Injector lobe ... 10.906 mm (0.4294 inch)
The maximum permissible difference between the actual lobe lift in Step 3 and the specified lobe lift is 0.13 mm (0.005 inch).
Caterpillar Information System:
349F and 352F Excavators Machine System Specifications Travel Counterbalance Valve
C2.2 Generator Sets Control Panel
C7 and C9 On-highway Engines Fuel System - Prime
TH48-E80 Petroleum Transmission Pressure Control Valve (Transmission)
325D and 329D Excavators Hydraulic System Hydraulic Tank and Filter
C9 Engines for Caterpillar Built Machines Coolant Temperature Sensor
C175 Generator Sets High Pressure Fuel Lines
Hydraulic Cylinder Honing {7562} Hydraulic Cylinder Honing {7562}
C7 On-highway Engine Water Lines
Installation of the 264-8897 Auxiliary Sea Water Pump Gp {1371} Installation of the 264-8897 Auxiliary Sea Water Pump Gp {1371}
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
C13, C15, and C18 Tier 4 Final Engines Crankshaft Seals
C9 Generator Set Safety Messages
C13 On-highway Engine Engine Oil Filter Base
C9 Generator Set Plate Locations and Film Locations
C9 Generator Set Model View Illustrations
C15 On-Highway Engine Crankshaft
C9 Engine for Caterpillar Built Machines Turbocharger - Remove
C13 On-highway Engine Front Housing and Covers
C9 Engine for Caterpillar Built Machines Turbocharger - Install
C9 Engine for Caterpillar Built Machines Cylinder Head - Remove
C15 On-Highway Engine Electronic Unit Injector
2006/02/06 A New Exhaust Manifold Gasket is Used {1059}
C15 and C18 Engines for Caterpillar Built Machines Electronic Unit Injector Rocker Arm