Water Temperature Regulators - Remove and Install - Jacket Water
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant. Refer to Operation and Maintenance Manual, "Coolant - Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g03785984 - Remove bolts (2) and position elbow (1) out of the way. Remove the gasket.
Show/hide table
Illustration 2 g03785988 - Disconnect the hose from elbow (4). Remove bolts (3) and remove temperature regulator housing assembly (5).
Show/hide table
Illustration 3 g03785990 - Remove O-ring seal (6) and remove water temperature regulator (7). Repeat for the remaining water temperature regulators.
- Install water temperature regulator (7) in the reverse order of removal.
Caterpillar Information System:
C13 Generator Set Engine Engine Oil Pan - Remove and Install
C2.2 Engines for Caterpillar Built Machines Temperature Sensor (Exhaust)
C7.1 Engines DEF Line Heater - Test
C2.2 Engines for Caterpillar Built Machines Temperature Sensor (DOC Inlet)
C2.2 Engines for Caterpillar Built Machines Belt Tension Chart
794 AC Off-Highway Truck Engine Supplement Hood - Remove and Install
C7.1 Engines DEF Control Module Power - Test
C7.1 Engines Data Link Configuration Status - Test
C13 Generator Set Engine Alternator - Remove and Install
2015/01/16 Cat® Reman Announces the Availability of Remanufactured Engines for Certain Electric Power Generation Applications {1000}
C13 Generator Set Engine Vibration Damper and Pulley - Remove and Install
C13 Generator Set Engine Flywheel - Remove and Install
3512E Engines Water Temperature Regulators - Remove and Install - SCAC
Field Procedure to Adjust the Steering Shaft on Certain Off-Highway Trucks{4310, 4343} Field Procedure to Adjust the Steering Shaft on Certain Off-Highway Trucks{4310, 4343}
2015/02/06 A New Special Instruction is Available to Adjust the Steering Shaft on Certain Off-Highway Trucks {4310}
C13 Generator Set Engine Exhaust Elbow - Remove and Install
C3.4B Engines NRS Mass Flow Rate Problem
C2.2 Engines for Caterpillar Built Machines Rocker Shaft
C2.2 Engines for Caterpillar Built Machines Valve Mechanism Cover
C15 Generator Set Rotating Rectifier - Inspect/Test
C7.1 Engines DEF Pump Motor - Test
G3500H 60Hz Generator Sets Overhaul (Major)
New O-Ring Seals Are Available for Ignition Coil Extenders on Certain G3500 and G3600 Engines {1550, 1561} New O-Ring Seals Are Available for Ignition Coil Extenders on Certain G3500 and G3600 Engines {1550, 1561}
3512E Engines Water Pump - Remove and Install