Engine Oil Filter Elements - Remove and Install
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 1U-9824 | Oil Drain Tool Group | 1 |
| 5N-5566 | Hose | 1 | |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Tooling (A) provides a means for draining the engine oil from the engine oil filter housing. Tooling (A) is used in order to remove the engine oil filter elements from the engine oil filter housing.
- Refer to Operation and Maintenance Manual, "Engine Oil and Filter- Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g03378501 - Remove bolts (1) , covers (2), and O-ring seals.
Show/hide table
Illustration 2 g03378838 - Remove engine oil filter elements (3).
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install engine oil filter elements (3) in the reverse order of removal.
Caterpillar Information System:
TA2 Technical Inspection for G3516H Engines{1000, 7565} TA2 Technical Inspection for G3516H Engines{1000, 7565}
CEM Locomotive Aftertreatment Maintenance Interval Schedule
C175-16 Locomotive Engine Coolant Temperature Is Low
C13 Engine for Caterpillar Built Machines Crankshaft - Remove and Install
C13 Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Connecting Rod Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Cylinder Liner - Remove and Install
C13 Engine for Caterpillar Built Machines Camshaft Bearings - Remove and Install
C175-16 Locomotive Engine Prelubrication - Test
C175-16 Locomotive Engine Injector Solenoid - Test
C13 Engine for Caterpillar Built Machines Camshaft - Remove and Install
3512E HD Petroleum Engine Plate Locations and Film Locations
390F MHPU Mobile Hydraulic Power Unit Diesel Exhaust Fluid - Fill
374F Excavator Cooling System Coolant Level - Check
3512C Petroleum Engines with Dynamic Gas Blending Air Shutoff - Test
CEM Locomotive Aftertreatment Configuration Parameters
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Work Tools
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Operation
C280-16 Engine Vibration Damper - Remove and Install
C13, C15, and C18 Tier 4 Final Engines Nitrogen Oxide Sensor
3512E Tier 4 Final Engines for Land Electric Drilling Coolant Temperature Is Low
2013/05/17 New Instrument Panel Box Gp Is Now Available On Certain Cat® Engines and Gensets {7451}
Procedure to Rework Primary and Secondary Throttle Circuits on Certain C32 Marine Engines{1408} Procedure to Rework Primary and Secondary Throttle Circuits on Certain C32 Marine Engines{1408}
C280-16 Engine Flywheel and Ring Gear - Remove and Install