Configuration Parameters
Parameter Settings of the SCR Inlet Temperature Monitoring System
The default settings for the parameters are programmed at the factory. The parameter settings for the engine monitoring system can also be viewed on Cat Electronic Technician (ET). In order to view the parameters of the engine monitoring system, refer to Troubleshooting Guide, "Engine Monitoring System".
Show/hide table
| High SCR Temperature Parameters | ||||
| Description | Action | Delay Time in Seconds | Trip Temperature | Default State |
| High SCR Temperature | Warning | 5 | 525° C (977° F) |
On |
| Derate (1) | 5 | N/A | On | |
| Forced Idle (2) | 5 | 585° C (1085° F) |
On | |
| Shutdown (3) | 5 | 600° C (1112° F) |
On | |
Show/hide table
| ( 1 ) | Refer to derate schedule below. |
| ( 2 ) | Operator can reset fault up to three times. A power reset required third attempt to clear fault. |
| ( 3 ) | A power reset required to clear fault. |
Show/hide table
 | |
| Illustration 1 | g03378947 |
Caterpillar Information System:
3512C Petroleum Engines with Dynamic Gas Blending Air Shutoff - Test
374F Excavator Cooling System Coolant Level - Check
390F MHPU Mobile Hydraulic Power Unit Diesel Exhaust Fluid - Fill
C280-16 Engine Engine Oil Filter Elements - Remove and Install
TA2 Technical Inspection for G3516H Engines{1000, 7565} TA2 Technical Inspection for G3516H Engines{1000, 7565}
CEM Locomotive Aftertreatment Maintenance Interval Schedule
C175-16 Locomotive Engine Coolant Temperature Is Low
C13 Engine for Caterpillar Built Machines Crankshaft - Remove and Install
C13 Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Connecting Rod Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Cylinder Liner - Remove and Install
C13 Engine for Caterpillar Built Machines Camshaft Bearings - Remove and Install
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Work Tools
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Operation
C280-16 Engine Vibration Damper - Remove and Install
C13, C15, and C18 Tier 4 Final Engines Nitrogen Oxide Sensor
3512E Tier 4 Final Engines for Land Electric Drilling Coolant Temperature Is Low
2013/05/17 New Instrument Panel Box Gp Is Now Available On Certain Cat® Engines and Gensets {7451}
Procedure to Rework Primary and Secondary Throttle Circuits on Certain C32 Marine Engines{1408} Procedure to Rework Primary and Secondary Throttle Circuits on Certain C32 Marine Engines{1408}
C280-16 Engine Flywheel and Ring Gear - Remove and Install
3512C Petroleum Engines with Dynamic Gas Blending Component Location
3512C Petroleum Engines with Dynamic Gas Blending System Overview
3512C Petroleum Engines with Dynamic Gas Blending Sensor Signal (Analog, Passive) - Test
3512C Petroleum Engine with Dynamic Gas Blending Electronic Control System Operation