Cylinder Liner - Remove and Install
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 5P-8665     | Cylinder Liner Puller Gp     | 1     |
Start By:
- Remove the pistons and the connecting rods.
- Use Tooling (A) to remove cylinder liner (1) .
Show/hide table
Illustration 1 | g01005579 |
- Remove the O-ring seals from cylinder liner (1) .
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
B     | 2P-8260     | Cylinder Liner Installer     | 1     |
C     | 5P-3975     | Rubber Lubricant     | 1     |
- Install the O-ring seals on cylinder liner (1) .
Show/hide table
Illustration 2 | g03870706 |
- Apply Tooling (C) on the O-ring seals.
- Use Tooling (B) to install cylinder liner (1) .
Note: Refer to Testing and Adjusting, "Cylinder Liner Projection" for more information.
Note: If you are installing a cylinder pack, ensure that the corresponding crankshaft throw is at bottom center.
End By: Install the pistons and the connecting rods.
Caterpillar Information System:
C13 Engine for Caterpillar Built Machines Camshaft Bearings - Remove and Install
C175-16 Locomotive Engine Prelubrication - Test
C175-16 Locomotive Engine Injector Solenoid - Test
C13 Engine for Caterpillar Built Machines Camshaft - Remove and Install
3512E HD Petroleum Engine Plate Locations and Film Locations
C175-16 Locomotive Engine Fuel Priming Pump - Test
C175-16 Locomotive Engine Fuel Control - Test
C13 Engine for Caterpillar Built Machines Rocker Arm and Shaft - Remove and Install
C175-16 Locomotive Engine Electrical Power Supply - Test
C175-16 Locomotive Engine Data Link - Test
C175-16 Locomotive Engine Coolant Temperature Control Module - Test
C175-16 Locomotive Engine Configuration Parameters
C13 Engine for Caterpillar Built Machines Connecting Rod Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Crankshaft - Remove and Install
C175-16 Locomotive Engine Coolant Temperature Is Low
CEM Locomotive Aftertreatment Maintenance Interval Schedule
TA2 Technical Inspection for G3516H Engines{1000, 7565} TA2 Technical Inspection for G3516H Engines{1000, 7565}
C280-16 Engine Engine Oil Filter Elements - Remove and Install
390F MHPU Mobile Hydraulic Power Unit Diesel Exhaust Fluid - Fill
374F Excavator Cooling System Coolant Level - Check
3512C Petroleum Engines with Dynamic Gas Blending Air Shutoff - Test
CEM Locomotive Aftertreatment Configuration Parameters
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Work Tools