3512E HD Petroleum Engine Caterpillar


Plate Locations and Film Locations

Usage:

SPF743 MLX
Cat engines are identified with serial numbers, with performance specification numbers, and with arrangement numbers. In some of the cases, modification numbers are used. These numbers are shown on the Serial Number Plate and the Information Plate that are mounted on the engine.

Cat dealers need these numbers in order to determine the components that were included with the engine. This information permits accurate identification of replacement part numbers.

Serial Number Plate



Illustration 1g03723323
(1) Serial number plate

The Serial Number Plate is on the left side of the cylinder block near the rear of the engine.



Illustration 2g00123229
Serial Number Plate

The following information is stamped on the Serial Number Plate: engine serial number, model and arrangement number.

Information Plate



Illustration 3g03723326
(2) Information Plate

The Information Plate is on the left side top surface of the cylinder block in front of the front cylinder head.



Illustration 4g03721882
Information Plate

The following information is stamped on the Information Plate: engine maximum altitude, horsepower, high idle rpm, full load rpm, fuel settings and other information.

DOC Serial Number Plate



Illustration 5g03774300
(1) DOC serial number plate

Emission Compliance Certification Film



Illustration 6g03724830
(3) Emission compliance certification film

The emission film is located on top of cylinder 12 valve cover.



Illustration 7g03724831
Emission compliance certification film

Caterpillar Information System:

C175-16 Locomotive Engine Fuel Priming Pump - Test
C175-16 Locomotive Engine Fuel Control - Test
C13 Engine for Caterpillar Built Machines Rocker Arm and Shaft - Remove and Install
C175-16 Locomotive Engine Electrical Power Supply - Test
C175-16 Locomotive Engine Data Link - Test
C175-16 Locomotive Engine Coolant Temperature Control Module - Test
C175-16 Locomotive Engine Configuration Parameters
374F Excavator Cooling System Coolant (ELC) - Change
C175-16 Locomotive Engine Component Location
2013/05/03 A New Water In Fuel Amplifier Is Used On Certain C175 Marine and Petroleum Engines {1408, 4490, 7490}
3600 and C280 Diesel Engine Fluids Recommendations Distillate Diesel Fuel
C4.4 and C7.1 Engines Solenoid Valve - Test
C13 Engine for Caterpillar Built Machines Camshaft - Remove and Install
C175-16 Locomotive Engine Injector Solenoid - Test
C175-16 Locomotive Engine Prelubrication - Test
C13 Engine for Caterpillar Built Machines Camshaft Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Cylinder Liner - Remove and Install
C13 Engine for Caterpillar Built Machines Connecting Rod Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Crankshaft - Remove and Install
C175-16 Locomotive Engine Coolant Temperature Is Low
CEM Locomotive Aftertreatment Maintenance Interval Schedule
TA2 Technical Inspection for G3516H Engines{1000, 7565} TA2 Technical Inspection for G3516H Engines{1000, 7565}
C280-16 Engine Engine Oil Filter Elements - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.