Transmission Suction Screen - Clean
Show/hide table
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
Note: The suction screen can be found on the right hand side of the front of the transmission.
Note: It is not necessary to drain the transmission oil before removing the suction screen.
Show/hide table
Illustration 1 | g01296087 |
- Remove four bolts (1) from end cover (2).
Show/hide table
Illustration 2 g01296091 - Remove suction screen (3) from the housing.
- Wash the screen in a clean, nonflammable solvent.
- Inspect the screen for any damage. The screen may be damaged. Replace the screen with a new screen.
- Install clean suction screen (3) into the case housing.
- Reinstall end cover (2) with four bolts (1).
Caterpillar Information System:
3176C and 3196 Engines for Caterpillar Built Machines Fuel Priming Pump
C7 and C9 On-Highway Engines Retarder Does Not Activate
Overspeed Verification of the Marine Power Display (MPD){7410, 7427, 7490} Overspeed Verification of the Marine Power Display (MPD){7410, 7427, 7490}
Corrective Action for Speed/Timing Sensor{1901, 1912} Corrective Action for Speed/Timing Sensor{1901, 1912}
C15 On-Highway Engine Crankcase Pressure Sensor - Remove and Install
G3520C and G3520E Generator Set Engines Oil Pressure Is Low
C7 and C9 On-Highway Engines General Information
C13 and C15 On-highway Engines Driver Questionnaire Response
C13 and C15 On-highway Engines Symptom Troubleshooting
C7 and C9 On-Highway Engines Exhaust Has Black Smoke
C13 and C15 On-highway Engines Welding Precaution
C7 and C9 On-Highway Engines Acceleration Is Poor or Throttle Response Is Poor
C13 and C15 On-highway Engines Auxiliary Brake - Test
C13 and C15 On-highway Engines Indicator Lamp - Test
TA22 Transmission Relief Valve - Remove and Install - Lube Relief Valve
Using the Map Adjustment Feature{1901, 1902, 7620} Using the Map Adjustment Feature{1901, 1902, 7620}
307B, 311–330 B-D Series, 345–5090 B and C Series and M312-M322 A-D Series Excavators Bucket - Remove and Install
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Remove
12M Motor Grader Scarifier Lift Link Socket - Lubricate - If Equipped
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Install
12M Motor Grader Scarifier Teeth - Inspect/Replace - If Equipped
2006/09/01 277-4734 Bypass Harness Assembly Allows Cat Electronic Technician (Cat ET) to Communicate with ADEM IV:E2 Electronic Control Modules {0779, 0785, 1901, 1930}
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Injection Lines
C1.5 and C2.2 Engines for Caterpillar Built Machines Turbocharger