Corrective Action for Speed/Timing Sensor{1901, 1912}
- Engine:
- G3408C (S/N: 3WR1-UP; 6FW1-UP; 8YR1-UP; BAZ1-UP)
- G3412 (S/N: KAP1-UP; R7A1-UP)
- G3412C (S/N: 8LW1-UP; 9RR1-UP; 5KR1-UP; 6ZM1-UP)
- G3412 (S/N: KAP1-UP; R7A1-UP)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
Due to the sensitivity of the 265-9034 Speed Sensor Group , the following fault codes may be generated if the 265-9034 Speed Sensor Group is installed as a replacement for the 102-9029 Speed Sensor Group :
- Fault code 320-05 "Speed/Timing Sensor Open or Shorted High"
- Fault code 320-08 "Speed/Timing Sensor Signal is Noisy"
Solution
Replace any of the following sensors if the sensors are faulty with a 102-9029 Speed Sensor Group :
Replacing an old non-defective speed-timing sensor group with a new sensor group is not a warrantable repair.
Caterpillar Information System:
C15 On-Highway Engine Crankcase Pressure Sensor - Remove and Install
G3520C and G3520E Generator Set Engines Oil Pressure Is Low
C7 and C9 On-Highway Engines General Information
C13 and C15 On-highway Engines Driver Questionnaire Response
C13 and C15 On-highway Engines Symptom Troubleshooting
C7 and C9 On-Highway Engines Exhaust Has Black Smoke
C13 and C15 On-highway Engines Welding Precaution
C7 and C9 On-Highway Engines Acceleration Is Poor or Throttle Response Is Poor
14L Motor Grader Power Train Solenoid Valve (Parking Brake)
C280-12 and C280–16 Marine Engines Camshaft Drive Gear - Install
C13 and C15 On-highway Engines Vehicle Speed - Calibrate
C175-16 Locomotive Engine General Information (Air/Electric Starting System)
Overspeed Verification of the Marine Power Display (MPD){7410, 7427, 7490} Overspeed Verification of the Marine Power Display (MPD){7410, 7427, 7490}
C7 and C9 On-Highway Engines Retarder Does Not Activate
3176C and 3196 Engines for Caterpillar Built Machines Fuel Priming Pump
TA22-4WD Agricultural Transmission Transmission Suction Screen - Clean
C13 and C15 On-highway Engines Auxiliary Brake - Test
C13 and C15 On-highway Engines Indicator Lamp - Test
TA22 Transmission Relief Valve - Remove and Install - Lube Relief Valve
Using the Map Adjustment Feature{1901, 1902, 7620} Using the Map Adjustment Feature{1901, 1902, 7620}
307B, 311–330 B-D Series, 345–5090 B and C Series and M312-M322 A-D Series Excavators Bucket - Remove and Install
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Remove
12M Motor Grader Scarifier Lift Link Socket - Lubricate - If Equipped
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Install