Idler Gears (Rear) - Remove
拆卸步骤
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 138-7573 | 连杆支架 | 1 |
开始:
- 拆卸后壳体。 请参阅拆解和组装, "壳体（前）- 拆卸"。
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 拆下螺栓 (3) 和挡圈 (2) 。
Show/hide table
 | |
| 图 1 | g01296176 |
- 将合适的起吊设备连接到齿轮 (1) 。 齿轮 (1) 和齿轮 (8) 的重量约为 55 kg (121 lb)。 从轴 (9) 上拆下齿轮 (1) 和齿轮 (8) 。
- 拆下将齿轮 (1) 和齿轮 (8) 固定在一起的螺栓 (7) 。 分开齿轮。
- 如有必要，从齿轮 (8) 上拆卸轴承。
- 拆下螺栓 (10) 和轴 (9) 。
- 拆下螺栓 (6) 并安装工具 (A) 。
- 用工具 (A) 和一个合适的举升设备拆下轴 (11) 和齿轮 (4) 。 轴 (11) 和齿轮 (4) 的重量约为 41 kg (90 lb)。 拆下螺栓 (12) 。 拆下轴 (11) 和齿轮 (4) 。
- 拆下工具 (A) 、其余的螺栓 (6) 和挡圈 (5) 。 从轴 (11) 上拆下齿轮 (4) 。
- 如有必要，从齿轮 (4) 上拆卸轴承。
- 对于其他惰轮重复步骤 6 至步骤 9。
Caterpillar Information System:
307B, 311–330 B-D Series, 345–5090 B and C Series and M312-M322 A-D Series Excavators Bucket - Remove and Install
Using the Map Adjustment Feature{1901, 1902, 7620} Using the Map Adjustment Feature{1901, 1902, 7620}
TA22 Transmission Relief Valve - Remove and Install - Lube Relief Valve
C13 and C15 On-highway Engines Indicator Lamp - Test
C13 and C15 On-highway Engines Auxiliary Brake - Test
TA22-4WD Agricultural Transmission Transmission Suction Screen - Clean
3176C and 3196 Engines for Caterpillar Built Machines Fuel Priming Pump
C7 and C9 On-Highway Engines Retarder Does Not Activate
Overspeed Verification of the Marine Power Display (MPD){7410, 7427, 7490} Overspeed Verification of the Marine Power Display (MPD){7410, 7427, 7490}
Corrective Action for Speed/Timing Sensor{1901, 1912} Corrective Action for Speed/Timing Sensor{1901, 1912}
C15 On-Highway Engine Crankcase Pressure Sensor - Remove and Install
G3520C and G3520E Generator Set Engines Oil Pressure Is Low
12M Motor Grader Scarifier Lift Link Socket - Lubricate - If Equipped
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Install
12M Motor Grader Scarifier Teeth - Inspect/Replace - If Equipped
2006/09/01 277-4734 Bypass Harness Assembly Allows Cat Electronic Technician (Cat ET) to Communicate with ADEM IV:E2 Electronic Control Modules {0779, 0785, 1901, 1930}
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Injection Lines
C1.5 and C2.2 Engines for Caterpillar Built Machines Turbocharger
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Oil Lines
C7 Engines for Caterpillar Built Machines Water Temperature Regulator
C7 Engines for Caterpillar Built Machines Water Temperature Regulator
12M Motor Grader Work Tool Lift - Lubricate
320D and 323D Excavators Machine System Specifications Pilot Valve (Joystick)
C7 Engines for Caterpillar Built Machines Crankshaft