Welding Precaution
Proper welding procedures are necessary in order to avoid damage to electronic controls. Perform welding on the engine according to the following procedure:
- Turn the keyswitch to the OFF position.
- Disconnect the negative terminal from the battery.
- Disconnect the engine's electronic components from the wiring harnesses: ECM, actuators and sensors.
- Protect the wiring harnesses from welding debris and/or from welding spatter.
Show/hide table
NOTICE Do NOT use electrical components (ECM or sensors) or electronic component grounding points for grounding the welder.
- Connect the welder's ground cable directly to the engine component that will be welded. Place the clamp as close as possible to the weld in order to reduce the possibility of welding current damage to the engine bearings, to the electrical components, and to other engine components.
- Use standard welding procedures to weld the materials together.
Caterpillar Information System:
C7 and C9 On-Highway Engines Acceleration Is Poor or Throttle Response Is Poor
14L Motor Grader Power Train Solenoid Valve (Parking Brake)
C280-12 and C280–16 Marine Engines Camshaft Drive Gear - Install
C13 and C15 On-highway Engines Vehicle Speed - Calibrate
C175-16 Locomotive Engine General Information (Air/Electric Starting System)
2006/10/02 New 271-8590 Analyzer Gp (24-Volt) Quickly Identifies Starting and Charging System Problems {0709, 1406}
C7 Engines for Caterpillar Built Machines Turbocharger
C-10 and C-12 Truck Engines Cylinder Liner
C13, C15, and C18 Tier 4 Final Engines Fuel Filter Base
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Firmware - Update
C280-12 and C280–16 Marine Engines Camshaft Drive Gear - Remove
C7 Engines for Caterpillar Built Machines Valve Mechanism Cover
C7 and C9 On-Highway Engines Exhaust Has Black Smoke
C13 and C15 On-highway Engines Symptom Troubleshooting
C13 and C15 On-highway Engines Driver Questionnaire Response
C7 and C9 On-Highway Engines General Information
G3520C and G3520E Generator Set Engines Oil Pressure Is Low
C15 On-Highway Engine Crankcase Pressure Sensor - Remove and Install
Corrective Action for Speed/Timing Sensor{1901, 1912} Corrective Action for Speed/Timing Sensor{1901, 1912}
Overspeed Verification of the Marine Power Display (MPD){7410, 7427, 7490} Overspeed Verification of the Marine Power Display (MPD){7410, 7427, 7490}
C7 and C9 On-Highway Engines Retarder Does Not Activate
3176C and 3196 Engines for Caterpillar Built Machines Fuel Priming Pump
TA22-4WD Agricultural Transmission Transmission Suction Screen - Clean
C13 and C15 On-highway Engines Auxiliary Brake - Test