Crankcase Pressure Sensor - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolt (1). Remove nut (2). Disconnect harness assembly (3). Remove crankcase pressure sensor (4) .
Show/hide table
Illustration 1 | g01295358 |
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
- Install crankcase pressure sensor (4). Connect harness assembly (3). Install nut (2). Install bolt (1) .
Show/hide table
Illustration 2 | g01295358 |
Caterpillar Information System:
G3520C and G3520E Generator Set Engines Oil Pressure Is Low
C7 and C9 On-Highway Engines General Information
C13 and C15 On-highway Engines Driver Questionnaire Response
C13 and C15 On-highway Engines Symptom Troubleshooting
C7 and C9 On-Highway Engines Exhaust Has Black Smoke
C13 and C15 On-highway Engines Welding Precaution
C7 and C9 On-Highway Engines Acceleration Is Poor or Throttle Response Is Poor
14L Motor Grader Power Train Solenoid Valve (Parking Brake)
C280-12 and C280–16 Marine Engines Camshaft Drive Gear - Install
C13 and C15 On-highway Engines Vehicle Speed - Calibrate
C175-16 Locomotive Engine General Information (Air/Electric Starting System)
2006/10/02 New 271-8590 Analyzer Gp (24-Volt) Quickly Identifies Starting and Charging System Problems {0709, 1406}
Corrective Action for Speed/Timing Sensor{1901, 1912} Corrective Action for Speed/Timing Sensor{1901, 1912}
Overspeed Verification of the Marine Power Display (MPD){7410, 7427, 7490} Overspeed Verification of the Marine Power Display (MPD){7410, 7427, 7490}
C7 and C9 On-Highway Engines Retarder Does Not Activate
3176C and 3196 Engines for Caterpillar Built Machines Fuel Priming Pump
TA22-4WD Agricultural Transmission Transmission Suction Screen - Clean
C13 and C15 On-highway Engines Auxiliary Brake - Test
C13 and C15 On-highway Engines Indicator Lamp - Test
TA22 Transmission Relief Valve - Remove and Install - Lube Relief Valve
Using the Map Adjustment Feature{1901, 1902, 7620} Using the Map Adjustment Feature{1901, 1902, 7620}
307B, 311–330 B-D Series, 345–5090 B and C Series and M312-M322 A-D Series Excavators Bucket - Remove and Install
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Remove
12M Motor Grader Scarifier Lift Link Socket - Lubricate - If Equipped