Fuel Injection Lines
Show/hide table
 | |
| 图 1 | g01442026 |
(1) 喷油器管接头螺母的扭矩
- 所有型号 ... 20 N·m (15 lb ft)
Show/hide table
 | |
| 图 2 | g01442096 |
(2) 螺母的扭矩 ... 27 N·m (20 lb ft)
(3) 中空螺栓的扭矩 ... 2.5 N·m (22 lb in)
注: 拆下燃油管后，必须更换所有垫圈。
Caterpillar Information System:
2006/09/01 277-4734 Bypass Harness Assembly Allows Cat Electronic Technician (Cat ET) to Communicate with ADEM IV:E2 Electronic Control Modules {0779, 0785, 1901, 1930}
12M Motor Grader Scarifier Teeth - Inspect/Replace - If Equipped
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Install
12M Motor Grader Scarifier Lift Link Socket - Lubricate - If Equipped
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Remove
307B, 311–330 B-D Series, 345–5090 B and C Series and M312-M322 A-D Series Excavators Bucket - Remove and Install
Using the Map Adjustment Feature{1901, 1902, 7620} Using the Map Adjustment Feature{1901, 1902, 7620}
TA22 Transmission Relief Valve - Remove and Install - Lube Relief Valve
C13 and C15 On-highway Engines Indicator Lamp - Test
C13 and C15 On-highway Engines Auxiliary Brake - Test
TA22-4WD Agricultural Transmission Transmission Suction Screen - Clean
3176C and 3196 Engines for Caterpillar Built Machines Fuel Priming Pump
C1.5 and C2.2 Engines for Caterpillar Built Machines Turbocharger
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Oil Lines
C7 Engines for Caterpillar Built Machines Water Temperature Regulator
C7 Engines for Caterpillar Built Machines Water Temperature Regulator
12M Motor Grader Work Tool Lift - Lubricate
320D and 323D Excavators Machine System Specifications Pilot Valve (Joystick)
C7 Engines for Caterpillar Built Machines Crankshaft
C15 and C18 Petrolem Generator Set Engines ECM Software - Install
C1.5 and C2.2 Engines for Caterpillar Built Machines Fan Drive
390F Excavator Machine Systems Swing Drive - Disassemble
C7 Engines for Caterpillar Built Machines Crankshaft Seals
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Controller Board Battery - Replace