Start By:
- Remove the bottom guards. Refer to Disassembly and Assembly, "Bottom Guards - Remove and Install".
Personal injury or death can result from a fire. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system. Turn the disconnect switch OFF or disconnect the battery when changing fuel filters. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Open the right engine guard.
Show/hide table
Illustration 1 g00817290 - Loosen clamp (2).
- Move hose assembly (1) aside.
Show/hide table
Illustration 2 g00817296 - Remove shield (3).
Show/hide table
Illustration 3 g00817298 - Remove bolts (4) and washers.
- Loosen clamp (6).
- Remove tube assembly (5).
- Repeat Step 2 through Step 7 for the left side of the engine.
Personal injury or death can result from a fire. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system. Turn the disconnect switch OFF or disconnect the battery when changing fuel filters. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Install tube assembly (5) with washers, bolts (4), and clamp (6).
Show/hide table
Illustration 5 g00817296 - Install shield (3).
Show/hide table
Illustration 6 g00817290 - Place hose assembly (1) in position.
- Tighten clamp (2).
- Close the right engine guard.
- Repeat Step 1 through Step 5 for the left side of the engine.
Illustration 4 | g00817298 |
End By:
- Install the bottom guards. Refer to Disassembly and Assembly, "Bottom Guards - Remove and Install".