Electronic Control Module (Power Train) - Flash Program
Perform the following procedure in order to flash program the power train Electronic Control Module (ECM). The power train ECM is flashed in order to upgrade the software. Flash programming of the power train ECM must also be done if the power train ECM has been replaced. The Caterpillar Electronic Technician (ET) contains the program WinFlash. WinFlash is used in order to load software into the ECM. The following procedure is used in order to FLASH software into the power train ECM.
Procedure
- Connect the 7X-1425 Data Link Cable between the 7X-1700 Communication Adapter and the Electronic Technician.
- Connect the 139-4166 Data Link Cable between the 7X-1700 Communication Adapter and the diagnostic connector of the machine.
- Turn the disconnect switch and the key start switch to the ON position.
- Use WinFlash in order to load the software.
- Perform the necessary calibrations. For information on performing calibrations, refer to Testing and Adjusting, "Calibration and Programming".
Caterpillar Information System:
D8R Series II Track-Type Tractor Hydraulic System Pressure Reducing Valve
D10R Track-Type Tractor Engine Supplement Fuel Filter Base - Remove and Install
Improved Air Conditioning System on Large Track-Type Tractors Improved Air Conditioning System on Large Track-Type Tractors
D6R Series II Track-Type Tractor Power Train Steering Differential and Brake - Assemble
D7R Series II Track-Type Tractor Engine Supplement Engine Oil Filter Base - Assemble
D10R Track-Type Tractor Engine Supplement Air Cleaner - Remove and Install
D6R Series II Track-Type Tractor Power Train Steering Differential and Brake - Disassemble
966G Series II Wheel Loader and 972G Series II Wheel Loader Power Train MID 081 - CID 0444 - FMI 03
3306B Engine Supplement for 637G Wheel Scraper Slave Cylinder (Governor Control) - Disassemble
621G and 627G Wheel Tractor-Scrapers Machine Systems Push-Pull Hook - Remove and Install
980G Series II Wheel Loader Power Train Electronic Control Module (Power Train) - Replace
3306B Engine Supplement for 637G Wheel Scraper Slave Cylinder (Governor Control) - Install
D7R Track-Type Tractor Power Train Axle - Remove and Install
D10R Track-Type Tractor Engine Supplement Fumes Disposal - Remove and Install
D8R Series II Track-Type Tractor Hydraulic System Accumulator
966G Series II Wheel Loader and 972G Series II Wheel Loader Power Train MID 081 - CID 0444 - FMI 05
D10R Track-Type Tractor Engine Supplement Hydraulic Oil Cooler - Remove and Install
621G and 623G Wheel Tractor Power Train Transmission Hydraulic Control Valve - Install
621G and 623G Wheel Tractor Power Train Transmission Electronic Control Module - Remove and Install
3500B Engines for 5130B and 5230B Excavators MID 036 - CID 0295 - FMI 09 Unable to communicate with Transmission ECM
D3G, D4G and D5G Track-Type Tractors Sound Information and Vibration Information
980G Series II Wheel Loader Power Train Calibration and Programming
826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Calibration and Programming
D10R Track-Type Tractor Engine Supplement Oil Filter and Cooler Bypass Valve - Remove and Install