Boost Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g01144605 |
- Disconnect harness assembly (1).
- Remove boost pressure sensor (2). Remove the O-ring seal from the boost pressure sensor.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install the O-ring seal on boost pressure sensor (2).
- Install boost pressure sensor (2) and tighten to a torque of
20 ± 2 N·m (177 ± 18 lb in) . - Connect harness assembly (1).
Show/hide table
Illustration 2 | g01144605 |
Caterpillar Information System:
C4.4 Industrial Engine Piston Ring Groove - Inspect
C3.3 Industrial Engine Water Temperature Regulator - Test
C4.4 Industrial Engine Cooling System - Inspect
3500B Engines Engine Oil Sump Pump
2003/04/01 New Piston and Rod Group that Improves Cold Weather Operation {1225}
G3500B Engines Thermostatic Valve
3176C and 3196 Engines for Caterpillar Built Machines Inlet Manifold Temperature Sensor
G3520B Industrial Engine +8V Sensor Voltage Supply
C3.3 Industrial Engine Compression - Test
G3500B Engines Engine Oil Filter - Duplex
2003/08/01 Component-Based Troubleshooting is Available {7569}
2003/03/01 Use the Correct Tooling for Installing Piston Rings {1214, 1215}
C9 Marine Engines and C9 Marine Generator Sets Alternator - Remove and Install
EMCPII+ for Gas Engines GSC CID 0446 - FMI 12
C-10, C-12, C-15 and C-16 Industrial Engines CID 0247 FMI 09 J1939 Data Link communications
EMCPII+ for Gas Engines Block Diagram of Generator Set Control
EMCPII+ for Gas Engines Schematics and Wiring Diagrams
EMCPII+ for Gas Engines Engine Does Not Shutdown (for Engine with ECM)
EMCPII+ for Gas Engines Engine Does Not Shutdown (for Engine with EIS)
C1.5 and C2.2 Engines for Caterpillar Built Marine Generator Sets Engine Oil Pressure Switch
C1.5 and C2.2 Engines for Caterpillar Built Marine Generator Sets Engine Lifting Bracket
EMCPII+ for Gas Engines GSC CID 0100 - FMI 02 (for Engine with ECM)
EMCPII+ for Gas Engines GSC CID 0100 - FMI 02 (for Engine with EIS)
EMCPII+ for Gas Engines GSC CID 0110 - FMI 02 (for Engine with ECM)