Engine Oil Sump Pump
Show/hide table
图 1 | g01434049 |
(1) 集油槽泵总成 |
用以下步骤安装油吸油组件 (2) :
注: 组装前,使用白色 Loctite Breakloose PST 涂抹吸油组件的螺纹。
- 使螺母 (3) 与吸油组件保持接触,并用手拧紧螺母,直到 O 形密封圈接触到油底壳。
- 拧松吸油组件,直到 "UP"(上)字样处于 12 点位置。
- 将吸油组件保持在此位置,并将螺母拧紧至扭矩 150 ± 15 N·m (110 ± 11 lb ft)。
Caterpillar Information System:
2003/04/01 New Piston and Rod Group that Improves Cold Weather Operation {1225}
G3500B Engines Thermostatic Valve
3176C and 3196 Engines for Caterpillar Built Machines Inlet Manifold Temperature Sensor
G3520B Industrial Engine +8V Sensor Voltage Supply
C3.3 Industrial Engine Compression - Test
G3500B Engines Engine Oil Filter - Duplex
2003/08/01 Component-Based Troubleshooting is Available {7569}
2003/03/01 Use the Correct Tooling for Installing Piston Rings {1214, 1215}
Cold Weather Recommendations for On-Highway Diesel Truck Engines Coolant Recommendations
3054E Industrial Engine Engine Oil Relief Valve - Remove and Install - Engine with Balancer Group
Cold Weather Recommendations for On-Highway Diesel Truck Engines Fuel Recommendations
G3500B Engines Engine Oil Lines
C4.4 Industrial Engine Cooling System - Inspect
C3.3 Industrial Engine Water Temperature Regulator - Test
C4.4 Industrial Engine Piston Ring Groove - Inspect
C9 Marine Engines and C9 Marine Generator Sets Boost Pressure Sensor - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Alternator - Remove and Install
EMCPII+ for Gas Engines GSC CID 0446 - FMI 12
C-10, C-12, C-15 and C-16 Industrial Engines CID 0247 FMI 09 J1939 Data Link communications
EMCPII+ for Gas Engines Block Diagram of Generator Set Control
EMCPII+ for Gas Engines Schematics and Wiring Diagrams
EMCPII+ for Gas Engines Engine Does Not Shutdown (for Engine with ECM)
EMCPII+ for Gas Engines Engine Does Not Shutdown (for Engine with EIS)
C1.5 and C2.2 Engines for Caterpillar Built Marine Generator Sets Engine Oil Pressure Switch