Fuel Control Valve - Remove and Install
- Turn off the gas supply.
Show/hide table
Illustration 1 g00598031 - Remove two clamps (1) from the fuel supply line.
- Remove bolt (4) and disconnect linkage (3) from fuel control valve (2).
Show/hide table
Illustration 2 g00598035 - Remove four bolts (5) and two flanges (6).
- Remove fuel control valve (2).
- Inspect the condition of the O-ring seal on the bottom of the fuel control valve. Replace the O-ring seal, if necessary.
Show/hide table
Illustration 3 g00598035 - Install the fuel control valve with two flanges (6) and four bolts (5).
Show/hide table
Illustration 4 g00598031 - Connect linkage (3) to fuel control valve (2) and install bolt (4).
- Install two clamps (1) on the fuel supply line.
- Turn on the gas supply.
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 445 FMI 12 Run Relay Failed - Test
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 444 FMI 12 Starting Motor Relay Failed - Test
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Balancer Group - 3114 Engine Only
G3500 Engines Gas Pressure Regulator - Assemble
3126B Marine Engine Alternator and Regulator
G3500 Engines Gas Pressure Regulator - Disassemble
3126B Marine Engine Alternator and Regulator
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove - 3003 Engines
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Install - 3003 Engine
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 441 FMI 12 Oil Step Relay Failed - Test
G3500 Engines Gas Pressure Regulator - Install - High Pressure
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 336 FMI 2 Switch (Engine Control) Incorrect Signal - Test
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 446 FMI 12 Air Shutoff Relay Failed - Test
G3500 Engines Service Meter - Remove and Install
3126B Marine Engine Electric Starting Motor
G3500 Engines Cylinder Head - Disassemble
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 447 FMI 12 Fuel Control Relay Failed - Test
3126B Marine Engine Electric Starting Motor
3126B Marine Engine Electric Starting Motor
3500B Engines and 3500 Engines with EUI Option Prelubrication System
3126B Marine Engine Electric Starting Motor
G3516B and G3520B Generator Set Engines Air Starting Motor - Assemble
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 560 FMI 11 CAT Data Link Failure Mode Not Identified - Test
G3500 Engines Cylinder Head - Assemble