Crankshaft Front Seal
Usage:
Remove Crankshaft Front Seal
preparatory step:
a) remove vibration damper and pulley
1. Remove the crankshaft front seal using puller group (A).
Install Crankshaft Front Seal
1. Using tool setup (A), install the crankshaft front seal as follows:
2. Lubricate the lip of seal and the crankshaft with clean SAE 30 oil. Coat the outside diameter of seal with 7F2770 Rubber Cement. Position the seal (1) on crankshaft with lip of seal toward rear of engine.
3. Install the locator assembly and three retaining screws.
4. Position the ring-seal installer on the locator assembly.
5. Install the pusher plate and nut. Tighten the nut until pusher plate becomes solid against the locator assembly.
6. Remove the tool setup (A).
concluding step:
a) install vibration damper and pulley
Caterpillar Information System:
DISASSEMBLY AND ASSEMBLY D346 Vibration Damper And Pulley
DISASSEMBLY AND ASSEMBLY D346 Water Temp. Regulators
DISASSEMBLY AND ASSEMBLY D346 Aftercooler Water Pump
DISASSEMBLY AND ASSEMBLY D346 (Later Engine)
DISASSEMBLY AND ASSEMBLY D346 Water Pump
DISASSEMBLY AND ASSEMBLY D346 Piston Cooling Jets
DISASSEMBLY AND ASSEMBLY D346 Crankshaft Main Bearings
DISASSEMBLY AND ASSEMBLY D346 Connecting Rod Bearings
DISASSEMBLY AND ASSEMBLY D346 Oil Pump
DISASSEMBLY AND ASSEMBLY D346 Oil Pan
DISASSEMBLY AND ASSEMBLY D346 Oil Filter Base
DISASSEMBLY AND ASSEMBLY D346 Oil Cooler
DISASSEMBLY AND ASSEMBLY D346 Front Timing Gear Cover
DISASSEMBLY AND ASSEMBLY D346 Fuel Priming Pump
DISASSEMBLY AND ASSEMBLY D346 Fuel Transfer Pump
DISASSEMBLY AND ASSEMBLY D346 Fuel Filter Elements
DISASSEMBLY AND ASSEMBLY D346 Fuel Filter Housing
DISASSEMBLY AND ASSEMBLY D346 Fuel Injection Lines
DISASSEMBLY AND ASSEMBLY D346 Fuel Ratio Control
DISASSEMBLY AND ASSEMBLY D346 Governor
DISASSEMBLY AND ASSEMBLY D346 Variable Timing Unit
DISASSEMBLY AND ASSEMBLY D346 Fuel Injection Pump Housing
DISASSEMBLY AND ASSEMBLY D346 Exhaust Manifolds
DISASSEMBLY AND ASSEMBLY D346 Turbochargers