Magneto
Usage:
Remove & Install Magneto
1. Disconnect ground wires (1) from magneto (2). The bolts from the ground wires will need to be replaced.
2. Disconnect plug (4) from magneto (2).
3. Remove three bolts (3) and magneto (1).
NOTE: The following steps are for the installation of the magneto.
4. See the topic, Timing Of Magneto To Engine, in Testing & Adjusting, Form No. SENR4604.
5. Make sure the O-ring seal is installed on magneto (1). Install magneto (2) with three bolts (1).
6. Connect plug (4).
7. Connect ground wire (1) with the new bolt.
Caterpillar Information System:
3512 & 3516 SPARK IGNITED ENGINES Tachometer Drive
3512 & 3516 SPARK IGNITED ENGINES Air Starter
3512 & 3516 SPARK IGNITED ENGINES Service Meter
3500 SPARK IGNITED ENGINES Testing And Adjusting
3500 SPARK IGNITED ENGINES Systems Operation
3176 DIESEL TRUCK ENGINE JAKE BRAKE Control Module
3176 DIESEL TRUCK ENGINE JAKE BRAKE Diagnostic Mode
3176 DIESEL TRUCK ENGINE JAKE BRAKE Dash Module
3176 DIESEL TRUCK ENGINE JAKE BRAKE Troubleshooting The C-317 Engine Retarder Control Module (Without Dash-Module Equipped Control Module)
3176 DIESEL TRUCK ENGINE JAKE BRAKE Troubleshooting The C-317 Engine Retarder Control Module (With Dash-Module Equipped Control Module)
3176 DIESEL TRUCK ENGINE JAKE BRAKE Procedure:
3176 DIESEL TRUCK ENGINE JAKE BRAKE Equipment Required:
3512 & 3516 SPARK IGNITED ENGINES Magneto Drive
3512 & 3516 SPARK IGNITED ENGINES Gas Pressure Regulator Solenoid
3512 & 3516 SPARK IGNITED ENGINES Gas Pressure Regulator
3512 & 3516 SPARK IGNITED ENGINES Carburetor
3512 & 3516 SPARK IGNITED ENGINES Water Temperature Regulators
3512 & 3516 SPARK IGNITED ENGINES Thermostatic Valve
3512 & 3516 SPARK IGNITED ENGINES Water Pump
3512 & 3516 SPARK IGNITED ENGINES Oil Pump
3512 & 3516 SPARK IGNITED ENGINES Oil Filter Housing
3512 & 3516 SPARK IGNITED ENGINES Oil Filter Housing Support
3512 & 3516 SPARK IGNITED ENGINES Oil Pan
3512 & 3516 SPARK IGNITED ENGINES Oil Sequence Valves