Solenoid Valve (Centershift Lock)
Show/hide table
 | |
| 图 1 | g01398527 |
(1) 锁紧螺母的最终安装扭矩 ... 9.0 ± 0.5 N·m (80 ± 4 lb in)
(2) 218-9894 线圈
- 标称电压 ... 24 VDC
- 25 °C (77 °F) 环境温度和 121 °C (250 °F) 流体温度时的最大电压 ... 28.5 VDC
- 25 ± 5°C (77 ± 9°F) 时的线圈电阻 ... 32.6 ± 1.6 欧姆
- 25 °C (77 °F) 环境温度和 121 °C (250 °F) 流体温度时的最大电压 ... 28.5 VDC
工作温度范围 ... −40 到 121 °C (−40 到 250 °F)
(3) 电磁阀的最终安装扭矩 ... 115 ± 7 N·m (85 ± 5 lb ft)
注: 把电磁阀引线放在水平至少 15 度以下的位置。 将引线放低一些会减少进入电磁阀的湿气。
(4) 170-7485 滑阀组件
在温度为 105°C (221°F) 时用 SAE 10 油，当压力降为 690 kPa (100 psi) 时，就会得到以下的流量。 ... 8.1 L/min (2.1 US gpm)
Caterpillar Information System:
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Hydraulic and Steering System Pitch Cylinder (3-Point Hitch)
2006/08/21 A Improved Alternator Guard is Used {7310}
AccuGrade® GPS GPS Accuracy Mode - Set - GPS Accuracy Option
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Relief Valve (Torque Converter Inlet)
C18 Engines for Caterpillar Built Machines CID 0281 FMI 05 Engine Lamp open/short to +batt
C175-16 Locomotive Engine Pressure Sensor
C18 Engines for Caterpillar Built Machines CID 0281 FMI 06 Engine Lamp short to ground
2006/11/27 An Improved Oil Level Gauge for the Output Transfer Gear Is Used {3159}
Oil Passage in the Cylinder Head{1100, 1102} Oil Passage in the Cylinder Head{1100, 1102}
277C, 287C and 297C Multi Terrain Loaders Hydraulic System Oil - Change
277C, 287C and 297C Multi Terrain Loaders Lower Machine Frame - Clean
AccuGrade® GPS Startup
2007/01/15 A New Speed-Timing Sensor is Available {1912}
Bench Test Procedure For A 768C, 769C, 772B, and 773B Off-Highway Truck Torque Converter{3101, 3133} Bench Test Procedure For A 768C, 769C, 772B, and 773B Off-Highway Truck Torque Converter{3101, 3133}
Filtration Procedure for Articulated Truck Steering Oil {0680, 0768, 4304, 4332, 5056, 5057} Filtration Procedure for Articulated Truck Steering Oil {0680, 0768, 4304, 4332, 5056, 5057}
773F, 773F OEM, 777F and 777F OEM Off-Highway Trucks and 775F and 775F OEM Quarry Truck Vital Information Management System (VIMS) General Information
277C, 287C and 297C Multi Terrain Loaders Final Drive Oil - Change
D-Series and D2-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Final Drive Oil Level - Check
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Implement Electronic Control System General Information
246C, 256C, 262C and 272C Skid Steer Loaders Service Interval Chart
277C, 287C and 297C Multi Terrain Loaders Service Interval Chart
2006/11/27 The New Bevel Gears Improve Reliability {3159, 3256, 3258, 3270}
Failures in Hardware in VIMS ECM{7601} Failures in Hardware in VIMS ECM{7601}
2010/03/04 Orifices in the Brake Lines Improve the Performance of the Pressure Switches {1408, 4282, 4284}