Usage:
Start By:
a. remove drum assembly
| NOTICE |
|---|
Drum support components use elastic stop nuts in several places. After being disassembled, these nuts should be discarded and replaced with new parts. |
1. Attach a hoist and chain to drum support as illustrated. Weight of drum support on the front drum is approximately 331 kg (730 lbs.). Weight of the rear drum support is approximately 240 kg (529 lbs.).
2. Raise the hoist enough to support the drum support assembly. Remove the bolts, washers, and nuts securing the drum drive plate and gear reducer to the shock mounts.
3. Use the hoist to carefully remove the drum support assembly from the drum.
| NOTICE |
|---|
Check the condition of the rubber shock mounts. Replace any that show signs of severe cracking, fatigue or breakage. |
4. Remove the bolts and washers securing each shock mount to the drum head if shock mounts are to be replaced.
Install Drum Support (Propel Side)
1. Install shock mounts to drum head using bolts and washers if these parts have been disassembled.
2. Attach a hoist and chain to drum support as illustrated. Weight of drum drive plate is approximately 318 kg (700 lbs.). Weight of the rear drum support is approximately 275 kg (605 lbs.).
3. Use the hoist to raise the drum support assembly. Move into place against the shock mounts.
4. Secure the drum drive plate to the shock mounts with the bolts, washers, and nuts.
End By:
a. install drum assembly