Engine Oil Filter Base - Assemble
- Install plunger (15), spring (16), and plug (17) into oil filter base (13). Tighten plug (17) to a torque of
100 ± 15 N·m (74 ± 11 lb ft) .Show/hide tableIllustration 2 g02174948 - Install oil filter (14) onto oil filter base (13). Tighten oil filter (14) to a torque of
65 ± 3 N·m (48 ± 2 lb ft) .Show/hide tableIllustration 3 g01859195 - Install spacer (8), retainer (9), spring (10), seat (11), and bolt (12) into oil filter base (1).
Show/hide table
Illustration 4 g01859194 - Install valve (5), spring assembly (6), and plug (7) into oil filter base (1). Tighten plug (7) to a torque of
100 ± 15 N·m (74 ± 11 lb ft) .Show/hide tableIllustration 5 g01859193 - Install plunger (2), spring (3), and plug (4) into oil filter base (1). Tighten plug (4) to a torque of
100 ± 15 N·m (74 ± 11 lb ft) .
Show/hide table
Illustration 1 | g01859199 |
End By:
- Install the engine oil filter base.
Caterpillar Information System:
C6.6 Industrial Engine Camshaft Bearings
C13 Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
C7.1 Engines for Caterpillar Built Machines Vibration Damper and Pulley
C7.1 Industrial Engine and Generator Set System Overview
C7.1 Industrial Engine and Generator Set Glossary
3500 Industrial Engines Exhaust Flange
C13 Engines for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Cooler - Remove and Install
C175-16 Locomotive Engine Engine Misfires, Runs Rough or Is Unstable
G3500 Generator Sets Crankshaft Vibration Damper - Inspect - 1500 RPM G3520 engines (if equipped with an oil fed damper)
Using the Air Compressor Unloader Kit for On-Highway Engines{1803} Using the Air Compressor Unloader Kit for On-Highway Engines{1803}
Storage Procedure for Caterpillar Products {0355, 1000, 7000} Storage Procedure for Caterpillar Products {0355, 1000, 7000}
CX35-P800 Petroleum Transmission and Petroleum Power Train Packages Modulating Valve (Transmission Clutch) - Remove and Install
CX31-P600 Petroleum Transmission Well Servicing Modulating Valve (Transmission Clutch) - Remove and Install
C6.6 Industrial Engine Boost Pressure Sensor
C13 Engine for Caterpillar Built Machines Fuel Pressure Regulator - Remove and Install
C9.3 Engines for Caterpillar Built Machines Oil Pressure Is Low
C9.3 Tier 4 Interim Engines Oil Contains Fuel
C13 Engine for Caterpillar Built Machines Electronic Unit Injector Sleeve - Remove and Install
C6.6 Industrial Engine Front Housing and Covers
C7.1 Industrial Engine Turbocharger - Series Turbochargers
C6.6 Industrial Engine Electronic Control Module
C13 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove
C6.6 Industrial Engine Crankcase Breather