Water Separator
Usage:
Remove Water Separator
Show/hide table
NOTICE |
---|
Element (2) is free to fall when clamp (1) is released. |
1. Remove clamp (1) and element (2).
2. Disconnect line (4) from the water separator base.
3. Remove the two nuts and water separator base (3).
4. Remove three bolts (6), bracket (5) and spacers.
Install Water Separator
1. Put bracket (1) and three spacers in position. Install the three bolts. Tighten the bolts to a torque of 10 ± 2 lb.ft. (14 ± 3 N·m).
2. Put base (2) in position and install the nuts.
3. Connect line (3) to the base.
4. Put element (4) in position and install clamp (5).
NOTE: Make sure clamp (5) is tight because element (4) is free to fall.
Caterpillar Information System:
3208 INDUSTRIAL ENGINE Air Inlet Manifold (Later)
3208 INDUSTRIAL ENGINE Air Inlet Manifold
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE General Instructions
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE Testing And Adjusting
3208 INDUSTRIAL ENGINE System Operation
3208 INDUSTRIAL ENGINE Fan Mounting Pulley Assemblies
3208 INDUSTRIAL ENGINE Mounting Group For AT540, MT643, and MT653 Allison Transmission
3208 INDUSTRIAL ENGINE Engine Support Group 1N9939
3208 INDUSTRIAL ENGINE Power Take-Off Clutch
3208 INDUSTRIAL ENGINE Power Take-Off Clutch
3208 INDUSTRIAL ENGINE Oil Pan
3208 INDUSTRIAL ENGINE Oil Pan (Rear Sump)
3208 INDUSTRIAL ENGINE Turbocharger
3208 INDUSTRIAL ENGINE Turbocharger (AiResearch TM6140)
3208 INDUSTRIAL ENGINE Turbocharger (Schwitzer 4TF555)
3208 INDUSTRIAL ENGINE Turbocharger
3208 INDUSTRIAL ENGINE Turbocharger (Air Research TM5101)
3208 INDUSTRIAL ENGINE Water Temperature Regulators
3208 INDUSTRIAL ENGINE Fuel Filter And Base
3208 INDUSTRIAL ENGINE Fuel Injection Lines
3208 INDUSTRIAL ENGINE Fuel Injection Pump Housing And Governor
3208 INDUSTRIAL ENGINE Fuel Injection Pump Housing