Air Inlet Manifold (Later)
Usage:
Remove Air Inlet Manifold
start by:
a) remove turbocharger
1. Loosen clamps (1) and (2). Disconnect the hoses (3) from the manifold.
2. Remove seven bolts (6). Loosen one bolt (manifold has an opening [slot] in it for this bolt).
3. Disconnect fuel line (5).
4. Remove air inlet manifold (4) and its gaskets.
Install Air Inlet Manifold
1. Put the air inlet manifold (1) in position on cylinder block and install the seven bolts that hold the manifold in place. Tighten the one bolt (one in manifold slot).
2. Connect the fuel line (3) to the manifold.
3. Connect hoses (4) to the manifold and tighten clamps (2).
end by:
a) install turbocharger
Caterpillar Information System:
3208 INDUSTRIAL ENGINE Air Inlet Manifold
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE General Instructions
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE Testing And Adjusting
3208 INDUSTRIAL ENGINE System Operation
3208 INDUSTRIAL ENGINE Fan Mounting Pulley Assemblies
3208 INDUSTRIAL ENGINE Mounting Group For AT540, MT643, and MT653 Allison Transmission
3208 INDUSTRIAL ENGINE Engine Support Group 1N9939
3208 INDUSTRIAL ENGINE Power Take-Off Clutch
3208 INDUSTRIAL ENGINE Power Take-Off Clutch
3208 INDUSTRIAL ENGINE Sending Unit For Engine Oil Pressure 2N782 Sending Unit; Use with 2N781 Gauge.
3208 INDUSTRIAL ENGINE Water Separator
3208 INDUSTRIAL ENGINE Oil Pan
3208 INDUSTRIAL ENGINE Oil Pan (Rear Sump)
3208 INDUSTRIAL ENGINE Turbocharger
3208 INDUSTRIAL ENGINE Turbocharger (AiResearch TM6140)
3208 INDUSTRIAL ENGINE Turbocharger (Schwitzer 4TF555)
3208 INDUSTRIAL ENGINE Turbocharger
3208 INDUSTRIAL ENGINE Turbocharger (Air Research TM5101)
3208 INDUSTRIAL ENGINE Water Temperature Regulators
3208 INDUSTRIAL ENGINE Fuel Filter And Base
3208 INDUSTRIAL ENGINE Fuel Injection Lines
3208 INDUSTRIAL ENGINE Fuel Injection Pump Housing And Governor