Oil Pan
Usage:
Remove Oil Pan
1. Drain the oil from the engine.
2. Remove twenty-eight bolts, oil pan (1) and the gasket.
Install Oil Pan
1. Inspect the gasket for the oil pan. Install a new gasket if needed.
2. Put oil pan (1) in position and install the bolts. Tighten the bolts to a torque of 17 ± 3 lb.ft. (23 ± 4 N·m).
3. Fill the engine with oil to the correct level.
Caterpillar Information System:
3208 INDUSTRIAL ENGINE Water Separator
3208 INDUSTRIAL ENGINE Air Inlet Manifold (Later)
3208 INDUSTRIAL ENGINE Air Inlet Manifold
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE General Instructions
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE Testing And Adjusting
3208 INDUSTRIAL ENGINE System Operation
3208 INDUSTRIAL ENGINE Fan Mounting Pulley Assemblies
3208 INDUSTRIAL ENGINE Mounting Group For AT540, MT643, and MT653 Allison Transmission
3208 INDUSTRIAL ENGINE Engine Support Group 1N9939
3208 INDUSTRIAL ENGINE Power Take-Off Clutch
3208 INDUSTRIAL ENGINE Oil Pan (Rear Sump)
3208 INDUSTRIAL ENGINE Turbocharger
3208 INDUSTRIAL ENGINE Turbocharger (AiResearch TM6140)
3208 INDUSTRIAL ENGINE Turbocharger (Schwitzer 4TF555)
3208 INDUSTRIAL ENGINE Turbocharger
3208 INDUSTRIAL ENGINE Turbocharger (Air Research TM5101)
3208 INDUSTRIAL ENGINE Water Temperature Regulators
3208 INDUSTRIAL ENGINE Fuel Filter And Base
3208 INDUSTRIAL ENGINE Fuel Injection Lines
3208 INDUSTRIAL ENGINE Fuel Injection Pump Housing And Governor
3208 INDUSTRIAL ENGINE Fuel Injection Pump Housing
3208 INDUSTRIAL ENGINE Air - Fuel Ratio Control