Turbocharger
Usage:
Remove Turbocharger
1. Loosen hose clamps (1) on the inlet manifold.
2. Loosen clamps (2) and slide them back on tubes (3).
3. Remove two bolts (5) and then remove the turbocharger (4) from the engine block and inlet manifold.
4. Remove the two O-ring seals (6) from the engine block.
Install Turbocharger
1. Inspect all O-ring seals for wear or damage. Put a small amount of oil on the O-ring seals.
2. Put O-ring seals (1) in position in the engine block.
3. Put turbocharger (2) in position on the engine block and install the two bolts (4) that hold it.
4. Tighten hose clamps (3) on the inlet manifold.
5. Put clamps (5) in position and tighten them.
Caterpillar Information System:
3208 INDUSTRIAL ENGINE Turbocharger (Schwitzer 4TF555)
3208 INDUSTRIAL ENGINE Turbocharger (AiResearch TM6140)
3208 INDUSTRIAL ENGINE Turbocharger
3208 INDUSTRIAL ENGINE Oil Pan (Rear Sump)
3208 INDUSTRIAL ENGINE Oil Pan
3208 INDUSTRIAL ENGINE Water Separator
3208 INDUSTRIAL ENGINE Air Inlet Manifold (Later)
3208 INDUSTRIAL ENGINE Air Inlet Manifold
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE General Instructions
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE Testing And Adjusting
3208 INDUSTRIAL ENGINE Turbocharger (Air Research TM5101)
3208 INDUSTRIAL ENGINE Water Temperature Regulators
3208 INDUSTRIAL ENGINE Fuel Filter And Base
3208 INDUSTRIAL ENGINE Fuel Injection Lines
3208 INDUSTRIAL ENGINE Fuel Injection Pump Housing And Governor
3208 INDUSTRIAL ENGINE Fuel Injection Pump Housing
3208 INDUSTRIAL ENGINE Air - Fuel Ratio Control
3208 INDUSTRIAL ENGINE Check Valve And Bypass Valve
3208 INDUSTRIAL ENGINE Shutoff Housing
3208 INDUSTRIAL ENGINE Fuel Injection Pumps
3208 INDUSTRIAL ENGINE Water Pump
3208 INDUSTRIAL ENGINE Engine Oil Cooler And Oil Filter Base