Air Inlet Manifold
Usage:
Remove Air Inlet Manifold
1. Loosen clamps (1) and (3). Disconnect the hoses.
2. Remove bolts (2) and elbow (4).
3. Loosen clamps (6) and slide the hose on to the turbocharger.
4. Disconnect hose (8) from the fuel injection pump.
5. Remove bolts (5). Loosen bolt (9).
NOTE: Manifold (7) has opening (slot) in it for bolt (9).
6. Remove manifold (7) and the gaskets.
Install Air Inlet Manifold
1. Put gaskets (3) and manifold (1) in position and install the bolts.
2. Connect hose (4) to the fuel injection pump.
3. Put hose (2) in position and tighten the clamps.
4. Put elbow (5) in position and install the bolts.
5. Connect the hoses and tighten clamps (6) and (7).
Caterpillar Information System:
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE General Instructions
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE Testing And Adjusting
3208 INDUSTRIAL ENGINE System Operation
3208 INDUSTRIAL ENGINE Fan Mounting Pulley Assemblies
3208 INDUSTRIAL ENGINE Mounting Group For AT540, MT643, and MT653 Allison Transmission
3208 INDUSTRIAL ENGINE Engine Support Group 1N9939
3208 INDUSTRIAL ENGINE Power Take-Off Clutch
3208 INDUSTRIAL ENGINE Power Take-Off Clutch
3208 INDUSTRIAL ENGINE Sending Unit For Engine Oil Pressure 2N782 Sending Unit; Use with 2N781 Gauge.
3208 INDUSTRIAL ENGINE Gauge For Engine Oil Pressure 2N781 Gauge; Use with 2N782 Sending Unit.
3208 INDUSTRIAL ENGINE Air Inlet Manifold (Later)
3208 INDUSTRIAL ENGINE Water Separator
3208 INDUSTRIAL ENGINE Oil Pan
3208 INDUSTRIAL ENGINE Oil Pan (Rear Sump)
3208 INDUSTRIAL ENGINE Turbocharger
3208 INDUSTRIAL ENGINE Turbocharger (AiResearch TM6140)
3208 INDUSTRIAL ENGINE Turbocharger (Schwitzer 4TF555)
3208 INDUSTRIAL ENGINE Turbocharger
3208 INDUSTRIAL ENGINE Turbocharger (Air Research TM5101)
3208 INDUSTRIAL ENGINE Water Temperature Regulators
3208 INDUSTRIAL ENGINE Fuel Filter And Base
3208 INDUSTRIAL ENGINE Fuel Injection Lines