Track Shoe Bolts - Tighten
Show/hide table
| |
| 插圖 1 | g06125783 |
附註在螺栓的螺紋上塗上 SAE 30W 機油。
履帶板螺栓的所需扭矩為
Caterpillar Information System:
460-8972 Major Overhaul Foundational Kit for 3412 Generator Set Engines{1000} 460-8972 Major Overhaul Foundational Kit for 3412 Generator Set Engines{1000}
3516C Marine Engines Turbocharger Oil Lines
3516C Marine Engines Fuel Injector
462-1133 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000} 462-1133 Top End Overhaul Foundational Kit for 3412 Generator Set Engines{1000}
C27 and C32 Generator Set Engines Fan Drive
3306B-XQ200 Rental Generator Set Engine Refill Capacities
C13 Industrial Engine Diagnostic Capabilities
C4.4 Engines for Caterpillar Built Machines Aftertreatment SCR System Dosing - Test
2014/10/03 New Wiring Harnesses Are Used on Certain C175 Marine and Petroleum Engines {1408}
C13 Industrial Engine Diesel Particulate Filter Regeneration
2014/08/07 Ash Service Reset Clarification for Certain Truck Engines {108F}
C13 Industrial Engine General Information
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Speed Control - Test
3516C Marine Engines Exhaust Elbow
3512C Engine Air Inlet Manifold - Remove and Install
C175-16 Locomotive Engine Speed/Timing - Test
3516B Generator Set Engines with Dynamic Gas Blending Inlet Air Is Restricted
PM820, PM822, and PM825 Cold Planer Tracks - Inspect
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Transmission Oil Temperature Is High
PM820, PM822, and PM825 Cold Planer Upper Conveyor Deflectors (Second Stage) - Inspect/Replace
PM820, PM822, and PM825 Cold Planer Upper Conveyor Support Cables - Check
PM820, PM822, and PM825 Cold Planer Water Spray Nozzles - Clean
G3304B and G3306B Engines Air/Fuel Ratio Problem
PM820, PM822, and PM825 Cold Planer Water Spray System - Inspect