Piston Cooling Jets - Remove and Install
- Turn the battery disconnect switch to the OFF position.
- If necessary, remove components for access to side covers.
Show/hide table
Illustration 1 g03347983 - Remove bolts (1). Remove side cover (2).
Show/hide table
Illustration 2 g02400820 - Rotate the engine to position the piston toward top dead center for easy access. Refer to Testing and Adjusting, "Finding Top Center position for No. 1 Piston".
- Remove bolts (3). Remove piston cooling jet (4). Mark the location of dowel (5).
- Repeat Steps 2 through 5 for the remaining piston cooling jets.
- Rotate the engine to position the piston toward top dead center for easy access. Refer to Testing and Adjusting, "Finding Top Center position for No. 1 Piston".
Note: Point dowel (5) toward the connecting rod as shown. If, dowel (5) is pointed toward the crankshaft main will cause improper spray.
- Install piston cooling jet (4) with dowel (5) pointed inward toward the connecting rod. Install bolts (3).
Show/hide table
Illustration 4 g03347983 - Install side cover (2). Install bolts (1).
- If necessary, install components removed for access to side covers.
- Repeat Steps 1 through 4 for the remaining piston cooling jets.
- Turn the battery disconnect switch to the ON position.
Show/hide table
Illustration 3 | g02400820 |
Caterpillar Information System:
XQP1100 Generator Set Fuel and the Effect from Cold Weather
C175-16 Locomotive Engine Connecting Rod Bearings - Remove and Install
C175-16 Locomotive Engine Crankshaft Main Bearings - Remove and Install
C175-16 Locomotive Engine Fuel Priming Pump - Remove and Install
C7.1-XQ200 Rental Generator Set Refill Capacities
C280-16 Engine Engine Power Ratings
C175-16 Locomotive Engine Pistons, Liners, and Connecting Rods - Remove and Install
C7.1 Engines for Caterpillar Built Machines Turbocharger
C175-16 Locomotive Engine Camshaft Bearings - Remove and Install
C4.4 Engines for Caterpillar Built Machines Fuel Priming Pump - Mechanical Priming Pump
C175-16 Locomotive Engine Fuel Filter Base
C175-16 Locomotive Engine Fuel Filter Base
C175-16 Locomotive Engine Gear Group (Rear) - Remove and Install
C175-16 Locomotive Engine Fuel Transfer Pump - Remove and Install
C175-16 Locomotive Engine Idler Gears (Front) - Remove and Install
C175-16 Locomotive Engine High Pressure Fuel Rails - Remove and Install
C175-16 Locomotive Engine Flywheel Housing - Remove and Install
C32 Marine Engines Flywheel Housing
C7.1 Industrial Engine Refill Capacities
C32 Marine Engines Water Manifold - Exhaust
C32 Marine Engines Water Pump
C32 Marine Engines Turbocharger
C32 Marine Engines Water Lines
C175-16 Locomotive Engine Flow Limiter - Remove and Install