Installing the 395-1129 Guard Kit on Certain 950M and 962M Wheel Loaders {3259, 7185} Caterpillar

Wheel Loader

950M (S/N: EMB1-UP; XCJ1-UP; FTR1-UP; J1S1-UP)

962M (S/N: EJB1-UP; JYD1-UP; J2S1-UP; F2T1-UP)

Introduction

This Special Instruction will provide information on the installation of 395-1129 Guard Kit.

Do not perform any procedure in this publication or order any parts until you understand the information that is contained in this publication.

Safety Section

Show/hide table

Improper operation, lubrication, maintenance or repair of this product can be dangerous and could result in injury or death. Do not operate or perform any lubrication, maintenance or repair on this product, until you have read and understood the operation, lubrication, maintenance and repair information.

Show/hide table

Use an appropriate lifting device that is rated for the specific load. Failure to do so can result in serious injury or death.

Required Parts

Axle Preparation

Illustration 1	g06056019
Dimensions for machining new holes (A) 76.04 mm (3 inch) (B) 149.24 mm (5.9 inch) (C) 26.2 mm (1 inch) (D) 165.4 mm (6.5 inch) (E) M10 x 1.5

Use the dimensions shown in Illustration 1 to machine 8 holes into each axle shaft in order to mount the guard assemblies.

Installing The Axle Guard

Location

Illustration 2	g03741007
Bottom view

Installation Procedure

Show/hide table

Illustration 3	g06056174
View of guard assemblies (1) 232-0929 Guard As (3) 8T-4121 Hard Washer (4) 8T-4186 Bolt

1. Install guard assemblies (1).
   Show/hide table

   Illustration 4	g06056176
   View of plate installation (2) 232-0928 Plate (3) 8T-4121 Hard Washer (4) 8T-4196 Bolt

2. Install plates (2).