Daily Inspection
For maximum service life of the transmission, make a thorough walk-around inspection before you operate the transmission.
Look around the transmission and under the transmission. Inspect the condition of all major components. Look for the following discrepancies:
- loose bolts
- trash buildup
- oil leaks
- broken parts or worn parts
- cracks in the case
Remove any trash and any debris. Report any condition that requires service to the shop. Make sure that any necessary repairs are completed before you operate the transmission.
Perform all daily service requirements at the begining of each shift. Refer to the Operation and Maintenance Manual for the procedures.
- Inspect hoses, tubes, and lines.
- Check the oil level in the transmission case.
- Remove trash buildup.
- Check for loose bolts.
- Check for oil leaks.
- Check for broken parts.
- Check the case for cracks.
Perform the following procedures on a daily basis:
- Operation and Maintenance Manual, "Transmission Oil Level - Check"
Caterpillar Information System:
3612 and 3616 Engines Crankshaft Front Seal - Install
3612 and 3616 Engines Crankshaft Front Seal - Remove
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Data - Capture
C13 and C15 On-highway Engines Power Take-Off - Test
C13 and C15 On-highway Engines Kickout Bypass - Test
2006/08/07 A New O-ring is Now Used {1063, 1380}
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Log File - Retrieve
2006/08/07 Marine Engines are Shipped Without Oil {1348}
C15 On-Highway Engine Inlet and Exhaust Valve Springs - Remove and Install
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Emergency Power Off - Reset
C27 and C32 Generator Set Engines Aftercooler - Remove
C15 On-Highway Engine Clean Gas Induction Cooler - Remove and Install
3612 and 3616 Engines Crankshaft Rear Seal - Remove
3612 and 3616 Engines Crankshaft Rear Seal - Install
C13 and C15 On-highway Engines Shutdown (PTO) - Test
C13 and C15 On-highway Engines Shutdown Timer (Idle) - Test
C7 Engines for Caterpillar Built Machines Valve Mechanism
C13 and C15 On-highway Engines Speed Control (PTO) - Test
3612 and 3616 Engines Crankshaft Front Gear - Remove and Install
3612 and 3616 Engines Crankshaft Rear Gear - Remove and Install
3508B, 3512B, and 3516B High Displacement Generator Sets Monitoring System
C13 and C15 On-highway Engines Starting Aid - Test
C13 and C15 On-highway Engines Tachometer - Test
C13 and C15 On-highway Engines Torque Limit - Test