C3.3 Industrial Engine Caterpillar

Removal Procedure

Start By:

1. Remove the camshaft. Refer to this Disassembly and Assembly Manual, "Camshaft - Remove and Install".

Show/hide table

Illustration 1	g01130526
Typical example

1. If the camshaft bearing (1) is worn or damaged use Tooling (A) in order to remove the bearing from the cylinder block.

Installation Procedure

1. Ensure that the bearing housing in the cylinder block is clean. Ensure that the oil hole in the bearing housing is clean and free from debris.
   Show/hide table

   Illustration 2	g01130526
   Typical example

   Note: Align the oil hole in camshaft bearing (2) with the oil hole in the cylinder block.

2. Use the Tooling (A) in order to install the camshaft bearing (1) into the bore in the cylinder block.

   Note: The camshaft bearing must be inserted until the front edge of the bearing is flush with the face of the recess in the cylinder block.

End By:

1. Install the camshaft. Refer to this Disassembly and Assembly Manual, "Camshaft - Remove and Install".