Lifter Group - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1U-7262 | Telescoping Magnet | 1 |
Start By:
- Remove the cylinder head if the cylinder head has not previously been removed. Refer to this Disassembly and Assembly Manual, "Cylinder Head - Remove".
- Remove the engine oil pan if the engine oil pan has not previously been removed. Refer to this Disassembly and Assembly Manual, "Engine Oil Pan - Remove and Install".
- Remove the camshaft. Refer to this Disassembly and Assembly Manual, "Camshaft - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (A) to remove each cam follower (1).
Note: Place an identification mark on each cam follower for installation purposes.
Show/hide table
Illustration 1 | g00540954 |
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1U-7262 | Telescoping Magnet | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Lubricate each cam follower (1) with clean engine oil.
Show/hide table
Illustration 2 g00540954 - Use Tooling (A) to install each cam follower (1) into the appropriate housing in the cylinder block.
Note: Ensure that each cam follower (1) is installed in the original location and that each cam follower is seated correctly.
End By:
- Install the camshaft. Refer to this Disassembly and Assembly Manual, "Camshaft - Remove and Install".
- Install the engine oil pan if this is the appropriate time. Refer to this Disassembly and Assembly Manual, "Engine Oil Pan - Remove and Install".
- Install the cylinder head if this is the appropriate time. Refer to this Disassembly and Assembly Manual, "Install".
Caterpillar Information System:
C3.3 Industrial Engine Camshaft Gear - Remove and Install
C3.3 Industrial Engine Camshaft Bearings - Remove and Install
C3.3 Industrial Engine Engine Oil Pan - Remove and Install
C3.3 Industrial Engine Pistons and Connecting Rods - Remove
C3.3 Industrial Engine Pistons and Connecting Rods - Disassemble
C3.3 Industrial Engine Pistons and Connecting Rods - Assemble
C3.3 Industrial Engine Pistons and Connecting Rods - Install
C3.3 Industrial Engine Crankshaft Main Bearings - Remove
C3.3 Industrial Engine Crankshaft Main Bearings - Install - Crankshaft in Position
C3.3 Industrial Engine Crankshaft - Remove
C3.3 Industrial Engine Crankshaft - Install
C3.3 Industrial Engine Crankshaft Gear - Remove and Install
C175-16 and C175-20 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Install
3512B Oil Well Servicing Engine (ADEM III) Starting Motor System
CX31 On-Highway Transmission Power Train Transmission and Torque Converter - Separate
CX31 On-Highway Transmission Power Train Transmission and Torque Converter - Connect
3500B Engines Radiator Core - Remove
3500B Engines Radiator Core - Install
2006/01/02 A New Water Pump is Now Used {1361}
C3.3 Industrial Engine Crankshaft Front Seal - Remove
C3.3 Industrial Engine Crankshaft Pulley - Remove and Install
C3.3 Industrial Engine Valve Mechanism Cover - Remove and Install
C3.3 Industrial Engine Gear Group (Front) - Remove
C3.3 Industrial Engine Gear Group (Front) - Install