Removal Procedure
Start By:
- Lower the bottom guard. Refer to Disassembly and Assembly, "Bottom Guards - Remove and Install".
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
- Close fuel shutoff valve (1) .
Illustration 1 | g01257519 |
- Disconnect hose assembly (3) and tube assembly (5) .
Illustration 2 | g01257537 |
- Remove bolts (2) .
- Remove fuel transfer pump (4) and the O-ring seal.
Installation Procedure
- Install fuel transfer pump (4) and the O-ring seal. Install bolts (2). Connect hose assembly (3) and tube assembly (5) .
Illustration 3 | g01257537 |
- Open fuel shutoff valve (1) .
Illustration 4 | g01257519 |
- Prime the fuel system. Refer to Operation and Maintenance Manual, "Fuel System - Prime".