Troubleshooting
Troubleshooting can be difficult. The technician must follow a logical process of eliminating possible causes and identifying the specific causes of the problems. Ensure that all of the systems and connections that are described in the Installation Manual are installed correctly. Refer to the Systems Operation/Testing and Adjusting, "Troubleshooting" for information on troubleshooting.
Caterpillar Information System:
C-10, C-12, C-15 and C-16 Industrial Engines System Overview
2000/11/01 Measuring Exhaust Back Pressure {1050}
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Electrical System
Air Conditioning and Heating R134a for All Caterpillar Machines Refrigerant Compressor Protection System
3608 Engine Air Starting System Operation
3054 and 3056 Marine Generator Set Engines Engine Oil Pressure Switch - Remove and Install
3054 and 3056 Marine Generator Set Engines Coolant Temperature Switch - Remove and Install
3054 and 3056 Marine Generator Set Engines V-Belts - Remove and Install
G3304 and G3306 Engines Carburetor - Adjust
365B, 365B Series II and 365BL Excavators SmartBoom Control - If Equipped
2001/01/01 A New Valve Stem Seal Is Used In The Cylinder Head Groups For All Landfill Applications: New Valve Guides Are Used In All Cylinder Head Groups: Reference Tables Identify Cylinder Head Components For G3500 Series Engines {1104}
3054, 3054B and 3056 Marine Engines Inlet and Exhaust Manifold - Install - 3056 Engine
3054, 3054B and 3056 Marine Engines Installation Guide Jacket Water Heater
3608 Engine Crankshaft Thrust - Measure
C-10, C-12, C-15 and C-16 Industrial Engines Sensors and Electrical Connectors
320E and 323E Excavators Boom and Stick Linkage - Lubricate - VA Boom (If Equipped)
3003, 3013, 3014 and 3024 Industrial Engines Cylinder Head Bolts - Tighten
C-10 and C-12 Industrial Engines Air Compressor
3126B Industrial Engines CID 0100 FMI 03 Engine Oil Pressure open/short to +batt
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Thermocouple Module
3054 and 3056 Marine Generator Set Engines Crankshaft Front Seal - Remove
3054 and 3056 Marine Generator Set Engines Crankshaft Front Seal - Install
C-9 Industrial Engine CID 0110 FMI 03 Engine Coolant Temperature open/short to +batt
2000/12/01 Change of Mounting Location for the Middle Vibration Isolator on All 3508 Generator Set Packages {1021}