Air Compressor
Show/hide table
 | |
| Illustration 1 | g00638646 |
(1) Air compressor
(2) Bolts
Apply 9S-3263 Thread Lock Compound to the threads of the bolts. Tighten the bolts to the following torque. ... 100 ± 20 N·m (75 ± 15 lb ft)
(3) Bolts
Tighten the bolts to the following torque. ... 55 ± 10 N·m (41 ± 7 lb ft)
Accessory Drive (Air Compressor)
Show/hide table
 | |
| Illustration 2 | g00754714 |
Typical example | |
(4) Nut
(5) Gear
Show/hide table
 | |
| Illustration 3 | g00848375 |
(1) Air compressor (4) Nut (5) Gear (6) Air compressor gear holder | |
Tighten nut (4) to the following torque 460 ± 60 N·m (340 ± 44 lb ft).
Tap drive gear (5) with a hammer and tighten nut (4) to the following torque 460 ± 60 N·m (340 ± 44 lb ft).
Caterpillar Information System:
3003, 3013, 3014 and 3024 Industrial Engines Cylinder Head Bolts - Tighten
320E and 323E Excavators Boom and Stick Linkage - Lubricate - VA Boom (If Equipped)
C-10, C-12, C-15 and C-16 Industrial Engines Sensors and Electrical Connectors
3608 Engine Crankshaft Thrust - Measure
3054, 3054B and 3056 Marine Engines Installation Guide Jacket Water Heater
3054, 3054B and 3056 Marine Engines Installation Guide Troubleshooting
C-10, C-12, C-15 and C-16 Industrial Engines System Overview
2000/11/01 Measuring Exhaust Back Pressure {1050}
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Electrical System
Air Conditioning and Heating R134a for All Caterpillar Machines Refrigerant Compressor Protection System
3608 Engine Air Starting System Operation
3054 and 3056 Marine Generator Set Engines Engine Oil Pressure Switch - Remove and Install
3126B Industrial Engines CID 0100 FMI 03 Engine Oil Pressure open/short to +batt
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Thermocouple Module
3054 and 3056 Marine Generator Set Engines Crankshaft Front Seal - Remove
3054 and 3056 Marine Generator Set Engines Crankshaft Front Seal - Install
C-9 Industrial Engine CID 0110 FMI 03 Engine Coolant Temperature open/short to +batt
2000/12/01 Change of Mounting Location for the Middle Vibration Isolator on All 3508 Generator Set Packages {1021}
C-9 Industrial Engine CID 0110 FMI 04 Engine Coolant Temperature short to ground
3054 and 3056 Marine Generator Set Engines Lifter Group - Remove and Install
3054 and 3056 Marine Generator Set Engines Crankshaft Gear - Remove and Install
3126B Industrial Engines CID 0262 FMI 03 5 Volt Sensor DC Power Supply short to +batt
3126B Industrial Engines CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
3126B Industrial Engines CID 0273 FMI 03 Turbo Outlet Pressure open/short to +batt