Flywheel Housing
Show/hide table
Illustration 1 | g00612544 |
Typical view |
(1) Bearing joint position
- The bearing joint position is the following dimension off the vertical axis. ... 15 degrees ± 1 degree
(2) Apply 1U-8846 Sealant to all sealing surfaces of the flywheel housing. The flywheel housing must be assembled and tightened to the cylinder block within ten minutes.
Show/hide table
Illustration 2 | g00612690 |
View A-A Typical on both sides |
(3) Bearing depth
- The bearing depth is the following distance from the inside face of the flywheel housing. ... 4.0 ± 0.5 mm (0.16 ± 0.02 inch)
(4) Rear face of block
Caterpillar Information System:
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) TPS Maximum Payload Speed Manager
320C Forest Machine Machine Systems Boom Cylinder - Assemble
320C Excavator Equipment Lowering with Engine Stopped
322C Excavator Machine Systems Stick Bearings and Seals - Remove
307C Excavator Window Wiper and Washer Control
330C Excavator Joystick Controls
2000/08/07 The Main Control Valve is Improved for Use with the "Bent Axis Travel Motor" {5051}
2013/10/14 New Expander Rings and Backup Rings are Available {0617}
2014/08/11 Diagnostic Cables and Harnesses Are Available {0785}
M325B Material Handler Machine Systems Check Valve (Stabilizer) - Assemble
M325B Material Handler Machine Systems Check Valve (Stabilizer) - Disassemble
330C Excavator Joystick Controls
307C Excavator Hydraulic System Gear Pump (Pilot) - Test
C-9 Engines for Caterpillar Built Machines Compression Brake
320C U Excavator Leaving the Machine
330C Excavator Securing the Machine
365B, 365B Series II and 365BL Excavators Window Wiper and Washer Control
G112, G115, G125 and G140 Mechanical Grapple Stick Bracket - Remove and Install
307C Excavator Hydraulic System Relief Valve (Line) - Test and Adjust
C-9 Engines for Caterpillar Built Machines Water Pump - V-Belt Pulley
C-9 Engines for Caterpillar Built Machines Water Pump - Pulley for Serpentine Belt
307C Excavator Hydraulic System Relief Valve (Blade) - Test and Adjust - If Equipped
G112, G115, G125 and G140 Mechanical Grapple Visual Inspection
307C Excavator Hydraulic System Gear Pump (Blade) - Test