Manual Barring Group - Assemble
组装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将护圈 (1) 、小齿轮 (2) 和垫圈 (5) 放置于轴 (6) 的合适位置。 安装螺栓 (7) 。
Show/hide table
图 1 | g00562622 |
- 将 O 形密封圈 (15) 安装到轴 (6) 上。 在 O 形密封圈上涂抹清洁的发动机机油。
- 将轴 (6) 安装在支架组件上。
- 将垫片放置于轴 (6) 上的合适位置。 安装导管 (3) 。 此时不要拧紧导管。
- 将弹簧 (4) 和垫圈 (10) 放置于轴上的合适位置。 安装环 (8) 。
- 将阀杆 (14) 和弹簧 (9) 放置于托架组件的合适位置。 安装导管 (11) 。
- 在杆 (14) 上安装螺母 (12) 和旋钮 (13) 。
- 拧紧导管 (3) 至 270 ± 25 N·m (200 ± 18 lb ft) 的扭矩。
End By: 安装手动盘机组件。 请参阅 拆解和组装, "手动盘机组件 - 安装"。
Caterpillar Information System:
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Control Panel (Engine)
G3606 and G3608 Engines Manual Barring Group - Disassemble
3600 Heavy Fuel Engines Gauges and Indicators
G3408 and G3412 Engines Fuel System
3412E, C30 and C32 Marine Engines Flywheel - Remove
G3408 and G3412 Engines Ignition System
3600 Heavy Fuel Engines Model View Illustrations
G3408 and G3412 Engines Air Starting System
G3408 and G3412 Engines Electrical System
G3606 and G3608 Engines Manual Barring Group - Install
G3408 and G3412 Engines Basic Block
G3408 and G3412 Engines Cooling System
G3408 and G3412 Engines Air Inlet And Exhaust System
G3606 and G3608 Engines Housing (Rear) - Remove
G3606 and G3608 Engines Housing (Rear) - Install
G3408 and G3412 Engines Governor Adjustment Procedure
G3408 and G3412 Engines Lubrication System
3412E, C30 and C32 Marine Engines Flywheel - Install
G3606 and G3608 Engines Flywheel and Coupling Guards - Remove and Install
G3408 and G3412 Engines Cooling System
Generator Set Control Panel for Switchgear Conversion CID 0100 FMI 08 Pressure Sensor (Engine Oil) Abnormal Signal - Test
3600 Distillate Fuel Engines Engine Power Ratings
Alignment of Two-Bearing Generators{4471} Alignment of Two-Bearing Generators{4471}
3412E, C30 and C32 Marine Engines Vibration Damper and Pulley - Remove and Install