Crankshaft Front Seal
Usage:
Remove Crankshaft Front Seal
preparatory step:
a) remove vibration damper and hub
1. Using puller group (A), remove crankshaft front seal.
Install Crankshaft Front Seal
1. Using tool setup (A), install the crankshaft front seal as follows:
2. Lubricate the lip of seal and the crankshaft with clean SAE 30 oil. Coat the outside diameter of seal with 8M8059 Loctite Sealant. Position the seal on crankshaft with lip of seal toward rear of engine.
3. Install the locator assembly and three retaining screws.
4. Position the seal ring installer on the locator assembly.
5. Install the pusher plate and nut. Tighten the nut until pusher plate becomes solid against the locator assembly.
6. Remove the tool setup (A).
concluding step:
a) install vibration damper and hub
Caterpillar Information System:
D346 Marine Engine Vibration Damper And Hub
D346 Marine Engine Water Temperature Regulators
D346 Marine Engine Oil Filter Housing
D346 Marine Engine Fuel Filter Housing
D346 Marine Engine Expansion Tank
D346 Marine Engine Fuel Priming Pump
D346 Marine Engine Alternator
D346 Marine Engine Piston Cooling Jets
D346 Marine Engine Crankshaft Main Bearings
D346 Marine Engine Oil Pump
D346 Marine Engine Oil Pan Base
D346 Marine Engine Connecting Rod Bearings
D346 Marine Engine Front Timing Gear Cover
D346 Marine Engine Front Balancer And Idler Gear
D346 Marine Engine Front Timing Gear Plate And Idler Gear
D346 Marine Engine Fuel Transfer Pump
D346 Marine Engine Fuel Injection Lines
D346 Marine Engine Fuel Ratio Control
D346 Marine Engine Governor
D346 Marine Engine Variable Timing Unit
D346 Marine Engine Fuel Injection Pump Housing And Governor
D346 Marine Engine Air Cleaner Housings
D346 Marine Engine Exhaust Manifold Heat Shields
D346 Marine Engine Exhaust Manifolds