You must be able to read all safety messages. Clean the safety messages in order to read the words. Clean the safety messages in order to see the pictures. Replace the safety messages in order to read the words. Replace the safety messages in order to see the pictures. In order to clean the safety messages, use a cloth, water, and soap. Do not use solvent, gasoline, etc.
Replace any damaged safety messages or missing safety messages. Replace any safety messages that cannot be read. If a safety message is on a part that has been replaced, a new safety message must be installed on the replacement part. See your dealer for a new film.
| |
| Illustration 1 | g02428241 |
| |
| Illustration 2 | g02438377 |
| |
| Illustration 3 | g02560636 |
This safety message is located on the operators platform near the exhaust stack and on the engine valve cover.
| |
| Illustration 4 | g01370904 |
 |
|
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility. |
This safety message is located on the operators platform near the exhaust stack.
| |
| Illustration 5 | g01372262 |
|
|
Falling from the machine could cause serious injury or death. Seat belts should be worn when driving the machine on public roads. |
This safety message is located on the operators platform near the exhaust stack.
| |
| Illustration 6 | g01370917 |
|
|
This machine is equipped with a Caterpillar Product Link communication device. When electric detonators are used, this communication device should be deactivated within In cases where the type of Product Link module cannot be identified, Caterpillar recommends that the device be disabled no less than |
This safety message is located on the battery cover.
| |
| Illustration 7 | g01370909 |
|
|
Explosion Hazard! Improper jumper cable connections can cause an explosion resulting in serious injury or death. Batteries may be located in separate compartments. Refer to the Operation and Maintenance Manual for the correct jump starting procedure. |
This safety message is located below the radiator access door. This message is also located near the primary fuel filter.
| |
| Illustration 8 | g01372256 |
|
|
Hot parts or hot components can cause burns or personal injury. Do not allow hot parts or components to contact your skin. Use protective clothing or protective equipment to protect your skin. |
This safety message is located on both tow arms near the screed travel lock pins. This safety message is also located on both hopper wings.
| |
| Illustration 9 | g01372258 |
|
|
Raised hopper wings can unexpectedly swing down and cause a crushing hazard which could result in serious injury or death. Always engage the hopper travel locks in order to secure the hopper in the raised position. Refer to Operation and Maintenance Manual, "Hopper Travel Lock" for directions on engaging the hopper travel lock. |
This safety message is located on each tow arm.
| |
| Illustration 10 | g01371644 |
|
|
Stay back a safe distance. No clearance for a person in this area when the machine turns. Severe injury or death from crushing could occur. |
This safety message is located on each tow arm.
| |
| Illustration 11 | g01372260 |
|
|
Stay clear of the work tool during operation. Entanglement could result in personal injury or death. |
This safety message is located on each tow arm.
| |
| Illustration 12 | g01370910 |
|
|
Do not use this surface as a step or platform. This surface may not support additional weight or may be slippery. Serious injury or death could occur from a fall. |
This safety message is located on the generator.
| |
| Illustration 13 | g01372247 |
|
|
WARNING! Shock/Electrocution Hazard! Read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could cause serious injury or death. |
This safety message is located on both sides of the machine below the accumulator valve.
| |
| Illustration 14 | g01372252 |
|
|
Hydraulic accumulator contains gas and oil under high pressure. Improper removal or repair procedures could cause severe injury. To remove or repair, instructions in the service manual must be followed. Special equipment is required for testing and charging. |
This safety message is located on the air cleaner. The following information is not applicable to machines that are equipped with an ether starting aid.
| |
| Illustration 15 | g01372254 |
|
|
Explosion hazard! Do not use ether! This machine is equipped with an air inlet heater. Using ether can create explosions or fires that can cause personal injury or death. Read and follow the starting procedure in the Operation and Maintenance Manual. |
Refer to Operation and Maintenance Manual, "Engine Starting" for the proper starting procedure.