Flywheel Housing Runout
Usage:
Face Runout (axial eccentricity) of the Flywheel Housing:
8T5096 Dial Indicator Group Installed
1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.
2. Put a force on the crankshaft toward the rear before reading the indicator at each point.
3. With dial indicator set at 0.00 mm (.000 in) at location (A), turn the crankshaft and read the indicator at locations (B), (C) and (D).
4. The difference between lower and higher measurements taken at all four points must not be more than 0.38 mm (.015 in), which is the maximum permissible face runout (axial eccentricity) of the flywheel housing.
Caterpillar Information System:
G3306 TRUCK ENGINE Flywheel Runout
G3306 TRUCK ENGINE Flywheel Housing
G3306 TRUCK ENGINE Flywheel
G3306 TRUCK ENGINE Trunnion
G3306 TRUCK ENGINE Crankshaft Pulley
G3306 TRUCK ENGINE Timing Gear Cover
G3306 TRUCK ENGINE Connecting Rod And Main Bearings
G3306 TRUCK ENGINE Bearing Surface (Journal) For Connecting Rods
G3306 TRUCK ENGINE Bearing Surface (Journal) For Main Bearings
G3306 TRUCK ENGINE Crankshaft
G3306 TRUCK ENGINE Belt Tension Chart
G3306 TRUCK ENGINE Piston And Rings
G3306 TRUCK ENGINE Flywheel Housing Bore
G3306 TRUCK ENGINE Starting Motor
G3306 TRUCK ENGINE Systems Operation
G3306 TRUCK ENGINE Testing And Adjusting
3176B INDUSTRIAL ENGINE Electronic Control Module (ECM)
3176B INDUSTRIAL ENGINE Personality Module (PM)
3176B INDUSTRIAL ENGINE Electric Starting Motor
3176B INDUSTRIAL ENGINE V-Belts
3176B INDUSTRIAL ENGINE Alternator
3176B INDUSTRIAL ENGINE Air Compressor
3176B INDUSTRIAL ENGINE Oil Filter & Oil Filter Base Assembly
3176B INDUSTRIAL ENGINE Oil Cooler