Personality Module (PM)
Usage:
Remove & Install Personality Module (PM)
1. Remove Allen head screw (4). Disconnect electrical connector (3).
2. Remove four bolts (1) and cover (2).
3. Remove the personality module from the electronic control module.
NOTE: Install the personality module in the reverse order of removal.
Show/hide table
| NOTICE |
|---|
Use care when installing the plug so it fits into the jack with no side stress. Be sure the O-ring seal is properly installed. |
Caterpillar Information System:
3176B INDUSTRIAL ENGINE Electronic Control Module (ECM)
G3306 TRUCK ENGINE Testing And Adjusting
G3306 TRUCK ENGINE Systems Operation
G3306 TRUCK ENGINE Starting Motor
G3306 TRUCK ENGINE Flywheel Housing Bore
G3306 TRUCK ENGINE Flywheel Housing Runout
G3306 TRUCK ENGINE Flywheel Runout
G3306 TRUCK ENGINE Flywheel Housing
G3306 TRUCK ENGINE Flywheel
G3306 TRUCK ENGINE Trunnion
G3306 TRUCK ENGINE Crankshaft Pulley
G3306 TRUCK ENGINE Timing Gear Cover
3176B INDUSTRIAL ENGINE Electric Starting Motor
3176B INDUSTRIAL ENGINE V-Belts
3176B INDUSTRIAL ENGINE Alternator
3176B INDUSTRIAL ENGINE Air Compressor
3176B INDUSTRIAL ENGINE Oil Filter & Oil Filter Base Assembly
3176B INDUSTRIAL ENGINE Oil Cooler
3176B INDUSTRIAL ENGINE Water Pump
3176B INDUSTRIAL ENGINE Coolant Conditioner
3176B INDUSTRIAL ENGINE Engine Oil Pump
3176B INDUSTRIAL ENGINE Fuel Priming Pump
3176B INDUSTRIAL ENGINE Fuel Filter & Fuel Filter Base
3176B INDUSTRIAL ENGINE Fuel Transfer Pump