Pressure Switch (Parking Brake Oil)
Show/hide table
 | |
| Illustration 1 | g00292351 |
(1) Torque for the pressure switch ... 48 ± 5 N·m (35 ± 4 lb ft)
Maximum actuation pressure at −40 to +120°C (−40 to +248°F) ... 8270 kPa (1200 psi)
Deactuation pressure at −40 to +120°C (−40 to +248°F) ... 6890 ± 345 kPa (1000 ± 50 psi)
Current rating at 28 VDC ... 1.5 amperes
Contacts (A) and (C) are normally closed below the deactuation pressure of the pressure switch.
Contacts (A) and (B) are normally open below the deactuation pressure of the pressure switch.
Caterpillar Information System:
Filtration Procedure for E Series Vibratory Compactors {0680, 0768, 5050, 5056} Filtration Procedure for E Series Vibratory Compactors {0680, 0768, 5050, 5056}
793D Off-Highway Truck Differential and Final Drive Oil Sample - Obtain
Instructions for Converting Hot Saw to Intermittent Saw {5051, 5051, 5057, 6543} Instructions for Converting Hot Saw to Intermittent Saw {5051, 5051, 5057, 6543}
Instructions for Converting Hot Saw to Harvester Head Saw{5051, 5051, 5057, 6543} Instructions for Converting Hot Saw to Harvester Head Saw{5051, 5051, 5057, 6543}
784C and 785C Off-Highway Truck/Tractors Differential and Final Drive Oil Level - Check
2005/04/18 An Improved Crankshaft is Used {1202}
2005/04/25 Improved Engine Software and Improved Monitor Software Now used {7490}
2010/08/02 An Improved Hydraulic Oil Cooler for R1300 and R1300G Load Haul Dump Machines is Now Used {1374}
RM-300 Soil Stabilizer Engine Oil and Filter - Change
AccuGrade® Laser (CB420) MID 114 - CID 2261 - FMI 02
784C and 785C Off-Highway Truck/Tractors Differential and Final Drive Oil - Change
2005/04/25 New Procedures Improve the Consistency of the Fluid Levels {7000}
ECM Replacement Procedure on 700 Series Articulated Trucks{7610} ECM Replacement Procedure on 700 Series Articulated Trucks{7610}
2005/04/25 Correction to Specifications , "Brake Control Valve (Service)" {4265}
2005/04/18 Replace the Gear when the Sleeve Bearing is Replaced {1212}
2005/04/18 Replace the Gear when the Sleeve Bearing is Replaced {1212, 1234}
120M and 12M Motor Graders Hydraulic and Steering System Accumulator (Blade Cushion)
C11 and C15 Engines for Caterpillar Built Machines Engine Temperature Sensor Open or Short Circuit - Test
3500 Engines Low Engine Oil Pressure
2005/09/26 New Fuel Transfer Pump {1256}
725, 730 and 730 Ejector Articulated Trucks Engine Supplement Water Pump - Remove
789C Off-Highway Truck Drive Shaft Slip Joint - Lubricate
320D, 321D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 336D2, 340D and 340D2 Excavators, 324D Forest Machine and 323D MHPU, 324D MHPU, 325D MHPU, 329D MHPU, 330D MHPU and 336D MHPU Mobile Hydraulic Power Units Machine Electronic Control System Using Caterpillar Electronic Technician to Determine Diagnostic Codes
784C and 785C Off-Highway Truck/Tractors Jacking Locations