Pressure Sensor (ARD Combustion Air) - Remove and Install
- Disconnect harness assembly (1) from pressure sensor (1).
- Remove pressure sensor (2).
Show/hide table
| |
| Illustration 1 | g03392913 |
- Install pressure sensor (2) in the reverse order of removal.
- Tighten pressure sensor (2) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
Note: Do not pre-tighten the sensor using the plastic portion of the sensor. Pre-tighten the sensor using the metal hex portion of the sensor. Damage can occur to the sensor if pre-tightened using the plastic portion of the sensor.
- Tighten pressure sensor (2) to a torque of
Caterpillar Information System:
General Troubleshooting Guidelines For Nitrite Levels For Certain Gas Engines {0769, 1000, 1352, 1395} General Troubleshooting Guidelines For Nitrite Levels For Certain Gas Engines {0769, 1000, 1352, 1395}
C18 Generator Set Engines Fuel Temperature Sensor - Remove and Install
G3512 Generator Set Refill Capacities
C9.3 Marine Auxiliary and Generator Set Engine Speed Control - Test
G3512 Generator Set Emergency Stopping
G3512 Generator Set Cold Weather Starting
G3512 Generator Set Before Starting Engine
323F SA and 323F LN Excavator and 323F LN MHPU Machine Systems Specifications Check Valve
C18 Generator Set Engines Fuel Pressure Sensor - Remove and Install
C18 Generator Set Engines Crankcase Pressure Sensor - Remove and Install
G3512 Generator Set Engines Sensor Signal (Analog, Active) - Test
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Alarms and Shutoffs
C18 Generator Set Engines Temperature Sensor (Catalyst Inlet) - Remove and Install
C9.3 Marine Auxiliary and Generator Set Engine Data Link - Test
C18 Generator Set Engines Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Belts - Inspect/Adjust/Replace
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Coolant (NGEC) - Change
G3512 Generator Set Engines Sensor Signal (Analog, Passive) - Test
C18 Generator Set Engines Pressure Sensor (DPF) - Remove and Install
3500C IMO III Engines Fuel Injector Adjustment
Installing New Radiator Core Washers on Certain 3516 Generator Sets {1353, 1377} Installing New Radiator Core Washers on Certain 3516 Generator Sets {1353, 1377}
Installation Instruction for the 340-6283 Engine Oil Filter Element for C175 Engines {1000, 1308, 7000, 7519} Installation Instruction for the 340-6283 Engine Oil Filter Element for C175 Engines {1000, 1308, 7000, 7519}
C18 Generator Set Engines Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C18 Generator Set Engines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install