Belts - Inspect/Adjust/Replace
Show/hide table
| |
| Illustration 1 | g03866645 |
Your engine is equipped with a serpentine belt that drives the alternator. For maximum engine performance and maximum utilization of your engine, inspect the belt for wear and for cracking. Replace the belt, if necessary.
To replace the belt, insert a ratchet with a square drive into the square hole that is located in belt tensioner (1). Rotate the belt tensioner counterclockwise in order to relieve tension on the belt. Remove the belt.
Install the new belt correctly, as shown. Be sure that the belt is fully seated on the pulleys. The correct tension will automatically be applied when the ratchet is removed.
Caterpillar Information System:
PM3516 Power Modules Maintenance Interval Schedule - Prime Power
PM3516 Power Modules Maintenance Interval Schedule - Standby
C27 and C32 Industrial Engines Product Lifting
C3.4B Engines Power Is Intermittently Low or Power Cutout Is Intermittent
C27 and C32 Industrial Engines Plate Locations and Film Locations
2015/07/31 New Software For Dynamic Gas Blending Land Drilling Applications is Now Used on Certain 3512B and 3512C Engines {4490, 7620}
2015/07/24 Cat® Reman Announces New Oil Pump Options for Certain Truck Engines {1304}
2015/07/24 Cat® Reman Announces New Oil Pump, Water Pump, and Oil Cooler Options for Certain Commercial Engines {1304, 1361, 1378}
C27 and C32 Industrial Engines Model View Illustrations
2015/09/25 A New Speed Controller and Actuator Are Available for Certain G3400 and G3500 Engines {1264, 1716, 1908}
2015/07/24 A New Oil Cooler Is Now Used for Certain3516C HD Marine Engines {1378}
C280 Marine Engines Emergency Stop - Test
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}
G3606 and G3608 Engines Detonation Sensor - Remove and Install
C280 Marine Engines Speed Control - Test
C18 Generator Set Maintenance Interval Schedule - Standby Generator Sets
C18 Generator Set Maintenance Interval Schedule - Standard
G3606 and G3608 Engines Camshaft Speed Sensor - Remove and Install
C280 Marine Engines Aftertreatment Identification Module - Test
C280 Marine Engines Prelubrication Pump Problem
C27 and C32 Industrial Engines Overhaul (Major)
G3606 and G3608 Engines Prechamber Check Valve - Remove and Install
340F and 352F Excavators Long Reach Front Operational Checks
C27 and C32 Industrial Engines Walk-Around Inspection