New Software For Dynamic Gas Blending Land Drilling Applications is Now Used on Certain 3512B and 3512C Engines {4490, 7620}
- Engine:
- 3512B (S/N: 4AW1-UP)
- 3512C (S/N: LLA1-UP; LN51-UP)
Description of Change: A new software is now used on the engines that are listed above. The new software addresses the issue of maximum substitution percentage not displaying on Dynamic Gas Blending (DGB) land drilling applications (Engine).
Adaptable To: The new software part number that replaces the former part number is listed in Table 1.
Show/hide table
Qty     | New Part Number     | Former Part Number     | Description     |
---|---|---|---|
1     | 466-9552     | 473-8904     | Generator Set Software Gp     |
Show/hide table
Sales Model     | Adaptable Serial Number     | Effective Serial Number     |
---|---|---|
3512B     | S/N:4AW1-1020     | S/N:4AW1021-UP     |
3512C     | S/N:LLA1-5161     | S/N:LLA5162-UP     |
S/N:LN51-101 | S/N:LN5102-UP     |
Caterpillar Information System:
2015/07/24 Cat® Reman Announces New Oil Pump Options for Certain Truck Engines {1304}
2015/07/24 Cat® Reman Announces New Oil Pump, Water Pump, and Oil Cooler Options for Certain Commercial Engines {1304, 1361, 1378}
C27 and C32 Industrial Engines Model View Illustrations
2015/09/25 A New Speed Controller and Actuator Are Available for Certain G3400 and G3500 Engines {1264, 1716, 1908}
2015/07/24 A New Oil Cooler Is Now Used for Certain3516C HD Marine Engines {1378}
C280 Marine Engines Emergency Stop - Test
C280 Marine Engines Air Shutoff - Test
G3606 and G3608 Engines Valve Cover - Remove and Install
C27 and C32 Industrial Engines Safety Messages
C3.4B Engines Fuel Consumption Is Excessive
C3.4B Engines Acceleration Is Poor or Throttle Response Is Poor
3512C Petroleum Engines with Dynamic Gas Blending Timing - Calibrate
C27 and C32 Industrial Engines Plate Locations and Film Locations
C3.4B Engines Power Is Intermittently Low or Power Cutout Is Intermittent
C27 and C32 Industrial Engines Product Lifting
PM3516 Power Modules Maintenance Interval Schedule - Standby
PM3516 Power Modules Maintenance Interval Schedule - Prime Power
C27 and C32 Industrial Engines Belts - Inspect/Adjust/Replace
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}
G3606 and G3608 Engines Detonation Sensor - Remove and Install
C280 Marine Engines Speed Control - Test
C18 Generator Set Maintenance Interval Schedule - Standby Generator Sets
C18 Generator Set Maintenance Interval Schedule - Standard
G3606 and G3608 Engines Camshaft Speed Sensor - Remove and Install