A New Oil Cooler Is Now Used for Certain3516C HD Marine Engines {1378}
- Engine:
- 3516C (S/N: PAG1-UP; JTS1-UP)
Description of Change: The new oil cooler requires a new oil pump relief valve spring and new oil cooler bypass valve spring to maintain the correct system pressure.
Adaptable To: The new 191-9336 Oil Cooler Core replaces the existing 373-6537 Engine Oil Cooler and 10R-5667 Engine Oil Cooler. The new springs that are used with the oil cooler are 471-0040 Oil pump relief valve spring and 471-2751 Oil cooler bypass spring .
The new engine oil cooler is adaptable back to first production on the serial numbers listed above.
Refer to Table 1 for the new and former part numbers.
Show/hide table
New Part Number     | Former Part Number     |
191-9336     | 373-6537 10R-5667     |
Show/hide table
Qty     | New Part Number     | Description     |
1     | 471-0040     | Oil pump relief Valve Spring     |
1     | 471-2751     | Oil Cooler Bypass Spring     |
Show/hide table
Effective Serial Numbers     |
S/N:PAG00482-UP     |
S/N:JTS00561-UP     |
Caterpillar Information System:
C280 Marine Engines Emergency Stop - Test
C280 Marine Engines Air Shutoff - Test
G3606 and G3608 Engines Valve Cover - Remove and Install
C27 and C32 Industrial Engines Safety Messages
C3.4B Engines Fuel Consumption Is Excessive
C3.4B Engines Acceleration Is Poor or Throttle Response Is Poor
3512C Petroleum Engines with Dynamic Gas Blending Timing - Calibrate
352F Excavator Boom/Stick/Bucket Combinations
2015/07/17 Control Panel for C7.1 Engines {4490, 7451}
C280 Marine Engines Diagnostic Trouble Codes
C27 and C32 Industrial Engines Engine Crankcase Breather - Clean
Energy Storage System Diesel Generator Control Test
2015/09/25 A New Speed Controller and Actuator Are Available for Certain G3400 and G3500 Engines {1264, 1716, 1908}
C27 and C32 Industrial Engines Model View Illustrations
2015/07/24 Cat® Reman Announces New Oil Pump, Water Pump, and Oil Cooler Options for Certain Commercial Engines {1304, 1361, 1378}
2015/07/24 Cat® Reman Announces New Oil Pump Options for Certain Truck Engines {1304}
2015/07/31 New Software For Dynamic Gas Blending Land Drilling Applications is Now Used on Certain 3512B and 3512C Engines {4490, 7620}
C27 and C32 Industrial Engines Plate Locations and Film Locations
C3.4B Engines Power Is Intermittently Low or Power Cutout Is Intermittent
C27 and C32 Industrial Engines Product Lifting
PM3516 Power Modules Maintenance Interval Schedule - Standby
PM3516 Power Modules Maintenance Interval Schedule - Prime Power
C27 and C32 Industrial Engines Belts - Inspect/Adjust/Replace
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}