Model View Illustrations
The following model views show typical features of the engines that are supported in this service module. Due to individual applications, your engine may appear different from the illustrations.
Show/hide table
| |
| Illustration 1 | g03866268 |
|
Right Side View (1) Exhaust module (2) Fuel pump (3) Primary fuel filter/water separator (4) Engine oil filters (5) Exhaust cooler (6) Engine oil drain (7) Starting motor | |
Show/hide table
| |
| Illustration 2 | g03866269 |
|
Left Side View (8) Engine oil filler (9) Lifting eyes (10) Crankcase breathers ( 11) Engine oil level gauge (12) Alternator | |
Show/hide table
| |
| Illustration 3 | g03866324 |
|
Front View (9) Lifting eye (13) Secondary fuel filters (14) Coolant temperature regulator (15) Electronic Control Module (ECM) (16) Belt tensioner | |
Caterpillar Information System:
2015/09/25 A New Speed Controller and Actuator Are Available for Certain G3400 and G3500 Engines {1264, 1716, 1908}
2015/07/24 A New Oil Cooler Is Now Used for Certain3516C HD Marine Engines {1378}
C280 Marine Engines Emergency Stop - Test
C280 Marine Engines Air Shutoff - Test
G3606 and G3608 Engines Valve Cover - Remove and Install
C27 and C32 Industrial Engines Safety Messages
C3.4B Engines Fuel Consumption Is Excessive
C3.4B Engines Acceleration Is Poor or Throttle Response Is Poor
3512C Petroleum Engines with Dynamic Gas Blending Timing - Calibrate
352F Excavator Boom/Stick/Bucket Combinations
2015/07/17 Control Panel for C7.1 Engines {4490, 7451}
C280 Marine Engines Diagnostic Trouble Codes
2015/07/24 Cat® Reman Announces New Oil Pump, Water Pump, and Oil Cooler Options for Certain Commercial Engines {1304, 1361, 1378}
2015/07/24 Cat® Reman Announces New Oil Pump Options for Certain Truck Engines {1304}
2015/07/31 New Software For Dynamic Gas Blending Land Drilling Applications is Now Used on Certain 3512B and 3512C Engines {4490, 7620}
C27 and C32 Industrial Engines Plate Locations and Film Locations
C3.4B Engines Power Is Intermittently Low or Power Cutout Is Intermittent
C27 and C32 Industrial Engines Product Lifting
PM3516 Power Modules Maintenance Interval Schedule - Standby
PM3516 Power Modules Maintenance Interval Schedule - Prime Power
C27 and C32 Industrial Engines Belts - Inspect/Adjust/Replace
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}
G3606 and G3608 Engines Detonation Sensor - Remove and Install
C280 Marine Engines Speed Control - Test