Rocker Arm and Shaft - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 293-2989 | Lift Bracket As | 1 |
- Lubricate the contact points of pushrods (3) with clean engine oil. Install pushrods (3).
- Use Tooling (A) to install rocker arm and shaft (2).
- Install bolts (1).
- Tighten bolts (1) to a torque of
100 ± 20 N·m (74 ± 15 lb ft) in the sequence shown in Illustration 2. - Repeat Step4.
- Adjust the electronic unit injectors. Refer to Testing and Adjusting, "Electronic Unit Injector - Adjust".
- Adjust the engine valve lash. Refer to Testing and Adjusting, "Engine Valve Lash - Inspect/Adjust".
Show/hide table
Illustration 1 | g01861123 |
Show/hide table
Illustration 2 | g06381467 |
End By:
- Install the valve cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Caterpillar Information System:
C6.6 Industrial Engine Valve Mechanism Cover
C6.6 Industrial Engine Crankcase Breather
C13 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove
C6.6 Industrial Engine Electronic Control Module
C7.1 Industrial Engine Turbocharger - Series Turbochargers
C6.6 Industrial Engine Front Housing and Covers
C13 Engine for Caterpillar Built Machines Electronic Unit Injector Sleeve - Remove and Install
C9.3 Tier 4 Interim Engines Oil Contains Fuel
C9.3 Engines for Caterpillar Built Machines Oil Pressure Is Low
C13 Engine for Caterpillar Built Machines Fuel Pressure Regulator - Remove and Install
C6.6 Industrial Engine Boost Pressure Sensor
CX31-P600 Petroleum Transmission Well Servicing Modulating Valve (Transmission Clutch) - Remove and Install
C7.1 Engines for Caterpillar Built Machines Glow Plugs
C4.4 Industrial Engine Fuel Injection Nozzles
C13 Engine for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C13 Engine for Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
C7.1 Engines for Caterpillar Built Machines Crankshaft
C11 and C13 Engines Fuel Pressure Sensor
C12 Marine Engines Fuel Injector - Inspect/Adjust
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Magnetic Switch
2009/05/11 A New Wiring Harness for the Space Heater Is Used {1408, 664E}
C12 Marine Engines Engine Speed/Timing Sensor - Clean/Inspect
C15 and C18 Industrial Engines Inlet Air Temperature Sensor - Remove and Install
C12 Marine Engines Emissions Certification Film